Pelco c2462m-e manual Install Liner and Bubble, Dome Liner Installation

Page 18

Install Liner and Bubble

DOME LINER INSTALLATION

If the unit is supplied with a dome liner, reinstall the liner before installing the dome bubble (refer to Figure 13):

1.Align the studs located on the camera module with the clips on the liner.

2.Lightly pinch the sides of the liner, opposite from the clips, and place the clips over the studs.

3.When the liner is secure, position the viewing window of the liner over the lens of the camera.

4.Install the bubble (refer to Dome Bubble Installation on page 19).

Figure 13. Installing the Dome Liner

18

C2462M-E (3/09)

Image 18
Contents Camera System Contents List of Illustrations Important Safety Instructions Regulatory NoticesParts List DescriptionRemove the Dome Bubble Removing the Dome BubbleInstallation Surface Installation CEILING/WALLCeiling/Wall Installation IN-CEILING Installation Suspended Ceiling Standoff Back BOX Surface Mount Ring IN-CEILING Installation Fixed Ceiling or Wall Pinch the sidesSurface Installation 4S Standard Electrical BOX Standard Electrical Box InstallationIN-CEILING Installation 4S Deep Electrical BOX Deep Electrical Box InstallationCamera Positioning Camera Adjustments Switch SettingsFocus Adjustment To adjust the focus Loosen the focus locking screwVertical Phase Adjustment Install Liner and Bubble Dome Liner InstallationDome Bubble Installation Installing the Dome BubbleService Connector Attaching the 2.5 mm Monaural Headphone PlugSpecifications ElectricalRevision History Product Warranty and Return Information