IN-CEILING INSTALLATION: SUSPENDED CEILING
1.Remove the ceiling tile from the ceiling (refer to Figure 4).
2.Cut a
3.Remove the surface mount ring from the back box (refer to Figure 5 on page 10):
a.Place your fingers on the circular marks located on the sides of the surface mount ring.
b.Pinch the sides.
c.Lift and remove the surface mount ring from the back box. Do not discard the surface mount ring because it is required to complete the installation.
4.Turn the surface mount ring upside down and place it on the inside of the ceiling tile.
5.Attach the back box to the ceiling tile and surface mount ring with two
SURFACE MOUNT RING
CEILING
TILE
BACK BOX
Figure 4. Ceiling Tile Installation
6.Replace the ceiling tile.
7.Remove an adjacent ceiling tile and connect the video cable/wires.
BNC: Connect the BNC connector from the Camclosure to a mating BNC connector.
Twisted pair: Connect the blue wire to Video +; connect the gray wire to Video -.
8.Connect the power wires (refer to Table B).
Table B. Power Input: In-Ceiling, Suspended Ceiling Installation
Voltage | Red Wire | Black Wire |
|
|
|
12 VDC | + | Ground |
|
|
|
24 VAC | – | – |
|
|
|
9 |