Pelco C3453M-B manual Installing the SUN Shroud, Gland Cable Diameter, Model Number Input Voltage

INSTALLING THE SUN SHROUD

The optional sun shroud fits over the top of the EH1512 enclosure. Perform the following steps to install the sun shroud.

1.Position the front of the sun shroud above the front of the enclosure.

2.Press the sun shroud down and against the enclosure until the sun shroud snaps into place. Table A. Allowable Cable Diameter

Gland	Cable Diameter
PG9	0.181-inch to 0.312-inch
PG11	0.230-inch to 0.395-inch

NOTE: Conduit must be used if the cable diameter is greater than 0.395 inches (1.00 cm). RG11 coaxial might be greater than 0.395 inches.

Table B describes the minimum recommended cable sizes needed for use with the heater and blower combinations in the EH1512 enclosure.

WARNING: When using a single power source for both camera and accessories, consider the camera power consumption when determining the wire gauge. Table B does not include camera power.

Table B. Enclosure Accessory Wiring Distances

		Maximum Power
Model Number	Input Voltage	Consumption	Cable Size	Cable Distance
			20 AWG	2,782 ft (848 m)
EH1512-1	120 VAC	22 W	18 AWG	4,424 ft (1,348 m)
			16 AWG	7,035 ft (2,144 m)
			14 AWG	11,184 ft (3,409 m)
			20 AWG	142 ft (43 m)
EH1512-2	24 VAC	22 W	18 AWG	225 ft (69 m)
			16 AWG	358 ft (109 m)
			14 AWG	569 ft (173 m)
			20 AWG	6,473 ft (1,973 m)
EH1512-3	230 VAC	22 W	18 AWG	10,291 ft (2,137 m)
			16 AWG	16,365 ft (4,988 m)
			14 AWG	26,019 ft (7,931 m)
			20 AWG	2,782 ft (848 m)
EH1512-1MT,	120 VAC	22 W	18 AWG	4,424 ft (1,348 m)
EH1512-1MTS			16 AWG	7,035 ft (2,144 m)
			14 AWG	11,184 ft (3,409 m)
			20 AWG	142 ft (43 m)
EH1512-2MT,	24 VAC	22 W	18 AWG	225 ft (69 m)
EH1512-2MTS			16 AWG	358 ft (109 m)
			14 AWG	569 ft (173 m)
			20 AWG	6,473 ft (1,973 m)
EH1512-3MT,	230 VAC	22 W	18 AWG	10,291 ft (2,137 m)
EH1512-3MTS			16 AWG	16,365 ft (4,988 m)
			14 AWG	26,019 ft (7,931 m)

10 C3453M-B (4/09)