7.If you are using the EM1512 mount, attach the mount to the wall as follows:
a.Using the mount as a template, mark and drill holes in the mounting surface.
b.Pull the video and power cables from the wall through the mount. If wiring with conduit, use a step drill to drill a 0.875 inches (2.22 cm) hole in one of the three knockout locations for
c.Fasten the mount to the wall using a minimum of two flat washers (not supplied) and two
WARNINGS:
•If you install the mount outdoors, rainwater could leak through the mounting bolt holes and damage the wall. To prevent water damage, seal the bolt holes with an appropriate sealant. Apply the sealant around the bolt holes between the mount and the mounting surface.
•Use fasteners of a suitable size, and make certain the mounting surface can support the combined weight of the mount and camera/enclosure.
d.Pull the cables through the glands in the enclosure. If the glands are mounted outside the enclosure, tighten the glands around the cables. (If the glands are mounted inside the enclosure, do not tighten the glands around the cables until after you perform step 8.)
8.Attach the enclosure using the threaded mounting holes in the bottom of the enclosure. Use the M6 bolts and 6 mm split washer (supplied in the parts bag). Tighten the bolts to attach the enclosure body to the mount surface. Tighten the glands around the cables.
9.Adjust the enclosure position by loosening the M6 bolt at the bottom of the mount. Position the mount as desired, and then tighten the M6 bolt.
10.If you are not using the EM1512, pull the video and power cables through the glands or conduit on the bottom of the enclosure. Refer to Table B on page 10 to determine the size of power wire needed. Refer to Table D on page 11 to determine the type of video coaxial cable needed.
NOTE: Be sure to route all coaxial cable and wiring along the sides of the enclosure to avoid heating problems. Maintain separation between 120/230 VAC, 24 VAC, and video wiring.
11.Adjust the glands for a tight fit around the cables. If you are wiring the enclosure with conduit, install the fittings to connect the conduit to the enclosure.
12.Attach the camera to the sled with the Phillips screw and split washer (supplied in the parts bag), refer to Figure 4. Align the front of the lens with the front edge of the sled. Tighten the screw, and then reinsert the sled.
Figure 4. Attaching the Camera to the Sled
13.Refer to Figure 5 on page 9 for wiring power to the enclosure and the camera.
14.Attach the video cables to the camera.
15.If required, connect the ground to the boss and screw on the bottom of the enclosure, which is located in front of the PC board. For
16.Adjust the camera focal length and focus, if necessary.
17.Position the enclosure lid, close it, and then tighten the screws using a
8 |
|