Pelco C3453M-B manual Installation, Installing the Camera and Mount

Page 6

Installation

INSTALLING THE CAMERA AND MOUNT

To install the enclosure, camera, and lens:

1.Use a 5-mm Allen wrench (not supplied) to loosen the three screws on the enclosure base.

2.Lift up and remove the lid (refer to Figure 2). Hang the lid from the front of the enclosure base by the lanyards.

NOTE: The gasket can come loose when the lid is removed. Be sure to properly reseat the gasket, if necessary.

Figure 2. Removing the Lid

6

C3453M-B (4/09)

Image 6
Contents EH1512 Series Enclosures Contents List of IllustrationsList of Tables Important Safety Instructions Present within this unitLiterature accompanying this unit Description ModelsPackage Contents Installation Installing the Camera and MountC3453M-B 4/09 C3453M-B 4/09 EH1512 Wiring Diagram Installing the SUN Shroud Gland Cable DiameterModel Number Input Voltage Wire Gauge Total VA MaintenanceTable C VAC Wiring Distances Cable Type Maximum DistanceMechanical SpecificationsModels GeneralOptional Accessories Recommended MountsRecommended Cameras and Lenses CamerasLenses Product Warranty and Return Information Warranty