3.5FINAL INSTALLATION
1.If the pan/tilt is installed in an inverted position, refer to Figure 9 and apply RTV silicone (such as Bostik #9732 or equivalent) to the shaded areas of the covers.
2.Replace the covers.
a.Refer to Figure 10 and grasp one cover half in each hand and position the covers on each side of the pan/tilt unit.
b.Bring the two cover halves together, aligning the two pins in one cover half with the mating holes in the other cover half.
c.When the cover halves are together, press downward, as shown in Fig- ure 11, to force the covers into their latches.
d.Replace the screws in the covers.
3.If the pan/tilt is installed in an upright position, refer to Figure 12 and apply RTV silicone (such as Bostik #9732 or equivalent) to the shaded areas of the covers.
APPLY SILICONE SEALANT TO SHADED
AREAS BEFORE FINAL ASSEMBLY OF COVERS.
Figure 9. Silicone Application Locations for Inverted Unit
00083
Figure 10. Replacing the Cover Halves
Pelco Manual | 15 |