GE KTC-117V3, KTC-117V9 manual Making Cable Connections

Page 14

Making Cable Connections

KTC Compact Cameras

4)Loosen the ~AC24V terminal connectors on the terminal block and connect the power cable to them.

5)Tighten the terminal connector screws until snug, ensuring that the power leads are secure.

6)Connect the other end of the power cable to the power supply unit and tighten the connector screws until snug.

7)Supply power to the camera.

Note: When you supply power to the camera the PWR LED illuminates. If the PWR LED does not illuminate, check the terminal block connections and power source.

14	1041075C / November 2003

Image 14

Contents Page For technical support before and after installation, call Making Cable Connections Making Camera Adjustments Table of ContentsBefore YOU Begin Customer SupportIntroduction See for the camera models and their descriptionsCamera Back Panel Camera back panelFlicker Control FL OFF or on Programming the DIP SwitchBacklight Compensation BLC OFF or on Zoom Normal or E Zoom White Balance ATW or FIXView Normal or Mirror Installing the Bracket and Camera Mounting on a vertical surfaceMounting the Bracket Bracket partsAttaching the Camera to the Bracket Loosening the wing nut to free the ball and socket boltAdjusting the Camera Angle Tightening the wing nut to secure the camera positionPower and video connections Making Cable ConnectionsMaking Cable Connections Making Camera Adjustments Opening the HousingAdjusting the Camera Zoom and Focus Adjusting the Direct Drive LevelPage Page