JAI CV-M40 Locations and functions, CCD sensor Lens mount IT CCD sensor Mount type

		CV-M40
4. Locations and functions
		9	3	4	5
1	2	8			7	6

1.CCD sensor

2.Lens mount

:1/2 “ IT CCD sensor

:C-mount type

Note :

Rear protrusion on C- mount lens must be less than 10 mm (0.4 inch approx).

When IR-cut filter is used, it must be less than 7.0 mm (0.28 inch approx).

3.	BNC connector	:	Video output (VS 1.0 Vpp at 75 Ohm)
4.	SW1 switch	:	Shutter speed and function modes selection
5.	6 pin multi connector	:	RS 232 input and output / ext. trig input
6.	12 pin multi connector	:	+12V DC power / video output / sync. input and output
7.	Gain potentiometer	:	Gain level adjustment

8.Tripod mount plate

9.Screw holes for Tripod mount plate

CAUTION

When you mount the camera on your system, please make sure to use screws which have the length less than 5 mm from the camera bottom plate, as it may cause a serious damage to the PCB inside the camera when the length is more than 5 mm.

Please be advised that the supplied 4 screws for Tripod mount plate are to be used exclusively for MP-40, but not for any other mounting adaptor.

5