JAI CV-M40 operation manual Pin assignment, Pin connector DC IN/SYNC connector, IntSyncMode

CV-M40

5. Pin assignment

5-1. 12 pin connector (DC IN/SYNC connector)

Pin1No.	ExtSyncMode	HR10AExt-10RTrigger12PBMode-01 (Hirose)ExtmaleTriggerMode						IntSyncMode
	(Factorysetting)	H-Reset				HNon-reset
6			GND(VIDEO)
2				DC+12VIN
3
4					OUT
5	Ext.HDVIN	Ext.TRIGIN					Ext.HDIN	Int.HDVOUT
7
		OUT				Ext.TRIGIN
90	NC	PLCK/WENOUT			PLCK/WENOUT			NC
8				DC+12CGNDIN
12
1

*Note : To change the signal output on pin no. 6, 7 and 9, it is necessary to make jumper setting.

SeePin976“7no-.2.JumpersFactoryHDVNCinpupreon-tsetboard”PixelHDVforOthersclomoreckupuoutputinformations.

CAUTION

1.When trigger signal is input at #5 of 6 pin multi connector, do not input/output HD signal at #6 of 12 pin multi connector, as it causes a failure in Ext. trigger mode.

2.Do not use video output at the same time both from #4 of 12 pin multi connector and BNC connector, as it causes a failure on video signal due to double termination.

6