JAI CV-M40 operation manual Pin connector Trigger connector, Output, Male, RXDinput

CV-M40

5-2. 6 pin connector (TRIGGER connector)

Pin1no.		HD/VDinputHR10Aor					-7R-6PExt(Hirose).	male
			output	TXDoutputtrigger/readout
2				RXDinput
3				Ground
4
5*6			**SeenoteWEN2.		outputExt.triggerinput
* Note : 1. To change the si nal						on pin no. 5 and 6, it is necessary to make jumper setting.
	Pinno5		. FactoryTriggerpreinput-set				Others
		6	WENoutput				NC
	See “7-2. Jumpers			board” for more informations.

2. Do not input HD or VD signal at pin no.5, when the camera is set at Continuous mode.

CAUTION

When trigger signal is input at #5 of 6 pin multi connector, do not input/output HD signal at #6 of 12 pin multi connector, as it causes a failure in external trigger mode.

7