GE CG400 manual Playback on a TV Using the Antenna Connector, Normal TV Viewing

Playback on a TV Using the Antenna Connector

To connect your camcorder to a TV without audio/video inputs, additional accessories are required for this connection.

STOP PAUSE BLANK	OR
	RF Coaxial
	Cable*

VHF

IN

FROM

ANT

Back of TV

REW PLAY F.FWD EJECT		75-300 Ohm
		Transformer*
	CHANNEL
	4CH/3CH
V	Switch
A
Output Jacks
(Located behind	CRF800 RF
AV TERMINAL cover)	Output Adapter*	300-75 Ohm
		Transformer*

VHF	Back of TV
VHF Antenna
	OR
VHF Antenna

* Optional accessories are available from your dealer, local electronics store, or mail order. Order form is on page 5.

Playback Operation

1.Set the CHANNEL 4CH/3CH switch on the RF output adapter to channel 3 or 4.

2.Turn on the TV, and tune it to channel 3 or 4—same as RF output adapter.

3.Attach a power supply and turn on the camcorder.

4.Insert a tape.

5.Press the PLAY/CAM button to turn on PLAY mode.

The green indicator lights.

6.Press PLAY.

During playback, use the playback features described on page 24.

7.Press STOP on the camcorder when you are finished.

Watch What the Camcorder is Seeing (Or Recording)

1. Tune the TV to channel 3 or 4.

Tip: Turn down the TV’s volume to prevent a high-pitched squeal caused by feedback.

2.Set the CHANNEL 4CH/3CH switch on the RF output adapter to the same channel you selected on the TV.

3.Press the PLAY/CAM button to turn on the CAMERA mode.

4.Press the thumb trigger to watch what the camcorder is seeing (or recording) on the TV screen.

Normal TV Viewing

For normal TV viewing, leave the RF output adapter hooked to the TV. Disconnect the adapter from the camcorder or turn off the camcorder.

23