JAI CV-L105 operation manual Internal Trigger. Shutter mode, Timing for internal shutter mode

Page 12

CV-L105

6.2.2. Internal Trigger. Shutter mode.

In this mode, the camera does not require an EXT TRIG signal to be issued to the camera. The line rate (scan rate) is generated inside the camera. The camera will operate continuously with its internal trigger.

The scanning interval is equal to the time set by the SCAN parameter.

The exposure time is equal to the Shutter time set by the SHUTTER parameter via RS-232C. The permitted range for the scan rate is 151 µs to 32.5 ms (corresponds to 6.6 kHz to 30 Hz). The permitted range for the exposure time, SHUT value, is 1 µs up to (SCAN time – 150 µs). (Always less than SCAN.)

To use this mode:

 

 

Set function:

Trigger

Internal

 

Mode

SCAN

 

SHUTTER value

1 µs up to 32.35 ms

 

SCAN value

151 µs through 32.5 ms

 

Clock, Binning and other functions

 

Input:

Ext. trigger through the LVDS connector

 

Important notes on using this mode:-

•It is only recommended to use this mode when there is not change of speed in the object being scanned. If the speed of the object changes, the aspect ratio in the vertical (scanning) direction will change.

Scan interval = SCAN value

Exposure time

= SHUTTER value

Exposure

Data out

LEN

30 MHz 1t=33.3 ns

15 MHz 1t=66.6 ns Value in ( ) is for Binning

Fig. 13. Timing for internal shutter mode

- 11 -

Page 11 Page 13
Image 12
Page 11 Page 13
Contents CV-L105 Table of Contents CV-L105Main Features GeneralStandard Composition Locations and FunctionsPin Digital interface connector Pin AssignmentGND Pin Hirose connector Power Pin Dsub connector RS-232CTXD RXDInput and Output Circuits Video outputStrobe LEN RS-232C on/off enable/disable Trigger inputBinning select input Pixel rate select inputFunctions and Operations Principle of operationCV-L105 PC with Frame Horizontal Resolution VerticalEncoder Internal Trigger. Scan mode Trigger modesInternal Trigger. Scan mode ScanInternal Trigger. Shutter mode Timing for internal shutter modeExternal Trigger. Scan mode Timing for external trigger scan modeExternal Trigger. Shutter mode ShutterOther functions Configuring the Camera RS-232C control. Communication settingTrigger Mode Shutter/Scan ModeClock Select BinningGain and offset adjustment Communication and filesConfiguration via I/F connector and jumpers Potentiometers and jumpers placingExternal Appearance and Dimensions OutlinesSpecifications Specifications tableSpectral Sensitivity Users Mode Settings Users Modifications Users Record
Top Page Image Contents