CV-L105
6.3. Other functions
6.3.1. Binnig
Binning is a function where the signal from two neighbour pixels are added and read out as a single pixel. The sensitivity will be double, but the resolution will be the half. The binning function has no influence on the internal scan rate and shutter setting.
The function can be selected by
For configuration please refer to 7.2 and 7.3.
6.3.2. Pixel rate
The camera has 2 pixel clock frequencies, 30 MHz and 15 MHz. The pixel rate function selects the pixel clock for the data read out. The function has no influence on the internal scan rate and shutter setting. The max. scan rate with external trigger depends of the pixel clock.
The function can be selected by
6.3.3. RS-232C on/off
This function makes it possible to disable the
The function can be selected by internal jumpers or on the I/F connector pin #30. For configuration please refer to 7.2 and 7.3.
6.3.4. Offset and Gain
Inside the camera there are potentiometers to adjust red, green and blue offset and gain. They are used for the factory setting of the color balance. This is done for 3100K color temperature. Other adjustments can be done with the potentiometers. It is not recommended to torch the green gain and offset potentiometer, as they are the reference.
The adjustment is only for the factory setting. It has no function in the 4 user defined camera configurations and settings.
6.3.5. LED on rear
On the camera rear two LED indicators are found. The LED marked POWER will indicate that the power supply is on. The lower LED marked BUSY will light when external trigger is applied.
- 14 -