JAI CV-L105 operation manual Pin Assignment, Pin Digital interface connector, Gnd

CV-L105

5. Pin Assignment

5.1.68-pin Digital interface connector

(Digital video, control signals, trigger input)

Fig. 2. 68-pin digital interface. (Seen from camera rear.)

Pin			Pin
number	Signal	Remarks	number	Signal	Remarks
1	GND		35	GND
2	+RD7 out		36	-RD7 out
3	+RD6 out		37	-RD6 out
4	+RD5 out		38	-RD5 out
5	+RD4 out	Red Data out. LVDS	39	-RD4 out	Red Data out. LVDS
6	+RD3 out		40	-RD3 out
7	+RD2 out		41	-RD2 out
8	+RD1 out		42	-RD1 out
9	+RD0 out		43	-RD0 out
10	BIN in	Control inp. TTL *)	44	NC
11	+GD7 out		45	-GD7 out
12	+GD6 out		46	-GD6 out
13	+GD5 out		47	-GD5 out
14	+GD4 out	Green Data out. LVDS	48	-GD4 out	Green Data out. LVDS
15	+GD3 out		49	-GD3 out
16	+GD2 out		50	-GD2 out
17	+GD1 out		51	-GD1 out
18	+GD0 out		52	-GD0 out
19	+EXT TRIG in	LVDS in	53	-EXT TRIG in	LVDS in
20	+BD7 out		54	-BD7 out
21	+BD6 out		55	-BD6 out
22	+BD5 out		56	-BD5 out
23	+BD4 out	Blue Data out. LVDS	57	-BD4 out	Blue Data out. LVDS
24	+BD3 out		58	-BD3 out
25	+BD2 out		59	-BD2 out
26	+BD1 out		60	-BD1 out
27	+BD0 out		61	-BD0 out
28	NC		62	NC
29	GND		63	GND
30	RS-232 on/off	Control inp. TTL *)	64	NC
31	PIXEL RATE in	Control inp. TTL *)	65	NC
32	+STROBE out	LVDS out	66	-STROBE out	LVDS out
33	+LEN out	LVDS out	67	-LEN out	LVDS out
34	GND		68	GND

*) The control inputs are TTL and it has 4.7 kΩ pull up to +5V. The camera connector part number is Hirose DX10A-68S.

The connector to use on the cable side is Hirose DX31A-68P with back shell DX68-CV1

- 3 -