8
English
F_AUDIO (Front Audio Connector)
Connects to the audio connector located on the front panel of the system casing
(dependent on case design). When use of the front panel audio connector is required,
please remove the 5-6 pin, 9-10pin jumper.
Please note that use of only the front panel audio connector or the rear panel audio connector
is permitted.
CD_IN (Optical Drive Audio Connector)
Connects CD-ROM or DVD-ROM audio connector.
PIN SIGNAL
1CD_L
2GND
3GND
4CD_R
PIN SIGNAL
1MIC
2GND
3MIC_BIAS
4POWER
5Front Audio (R)
PIN SIGNAL
6Rear Audio (R)
7Reserved
8NO PIN
9Front Audio (L)
10 Rear Audio (L)
PWR_LED
Connects to the system power LED indicator whereby the power is indicated as ON or OFF.
However, the indicator will flash when the system is suspended.
PIN SIGNAL
1MPD+
2MPD-
3MPD-
1
SATA0/SATA1 (Serial ATA Connector, controlled by ICH5)
The SATA0/1 connector is able to connect a single Serial ATA device via a SATA cable.
For the connected SATA hard disk to work correctly, please check the related BIOS setting
and install proper driver for the SATA controller.
PIN SIGNAL
5RXN
6RXP
7GND
PIN SIGNAL
1GND
2TXP
3TXN
4GND
71
1
10
9
2
F_USB1 (Front USB Connector)
Connects to the USB connector located on the front panel of the system casing (dependent on
case design). Note: Please make sure that each USB connection matches its designated
position. If connections are made incorrectly, the result can lead to inability to use the function
or even damage. PIN SIGNAL
6USB Dy+
7GND
8GND
9NO PIN
10 NC
PIN SIGNAL
1POWER
2POWER
3USB Dx-
4USB Dy-
5USB Dx+
1
210
19