English

7

CPU_FAN (CPU Fan Power Connector); SYS_FAN (System Fan Power Connector)

The cooler fan power connector supplies a +12V power voltage via a 3-pin/4-pin(only for CPU_FAN)

power connector and possesses a ful-proof connection design.

Most coolers are designed with color-coded power connector wires. A red power connector wire indi-

cates a positive connection and requires a +12V power voltage. The black connector wire is the

ground wire (GND).

Please remember to connect the power to the cooler to prevent system overheating and failure.

Caution!

Please remember to connect the power to the CPU fan to prevent CPU overheating and failure.

ATX_12V (+12V Power Connector)

The ATX_12V power connector provides power to the CPU. If this connector is not Attached,

the system will not start.

ATX (ATX Power Connector)

The ATX power connector provides power to the motherboard. Prior to connection, please

make sure that the power supply is disconnected.

F_PANEL (Front Panel Control Connector)

The F_Panel Control Connector connects to certain connectors on the front panel of the

system casing such as IDE Hard Disk Active LED, speaker, reset, and power on/off connectors.

You can use the schematic diagram below as the basis for connection.

1
3
24
PIN SIGNAL
HD IDE Hard Disk Active LED
SPK Speaker Connector
RES Reset Switch
PW Soft Power Connector
MSG Message LED/Power/Sleep LED
NC NC
PIN SIGNAL
13.3V
23.3V
3GND
4VCC
5GND
6VCC
7GND
8Power Good
95VSB (stand by +5V)
10 +12V
PIN SIGNAL
11 3.3V
12 -12V
13 GND
14 PS_ON (soft on/off)
15 GND
16 GND
17 GND
18 -5V
19 VCC
20 VCC
1
CPU_FAN SYS_FAN
1
PIN SIGNAL
1GND
2GND
3+12V
4+12V
PIN SIGNAL
1GND
2+12V
3Sense
4Speed Control (Only for CPU_FAN)
20
11
10
1
1
2
19
20
HD-
HD+
RES+
RES-
NC
SPK-
MSG-
MSG+
PW-
PW+
SPK+