EverFocus ED610 specifications 4 BLC

Page 24

NOTES:

1 The maximum amplification in low light level situations can be adjusted by pressing the

SETUP button in “AUTO” mode. This sets an upper limit on the ‘boost’.

2 The image becomes brighter when the setting increases; however, the after image increases

as well. Due to the increased light sensitivity of the Super Had II chip, far less DSP ‘boost’ is needed, resulting in color or B/W images in low light with minimal ghosting.

3 Please note that spots and noise may appear if light amplification increases when SENSE-UP

is operating. This is a normal phenomenon, controllable with DNR.

3.4.4 BLC

Video gain can be adjusted automatically to correct the exposure of subjects that are in front of a bright light source.

1.Please direct the arrow to point to “BLC” by moving the joystick UP and DOWN.

2.Select the BLC mode by pressing the LEFT or RIGHT button. Then make adjustments as below:

GAIN:

Select from High, Middle and Low.

DEFAULT:

Set the factory default values for BLC.

LEFT/RIGHT:

Set the Left/Right side of an area for the BLC to be adjusted. The value adjustable is 0~6.

WIDTH:

Set the width of an area for the BLC to be adjusted. The value adjustable is 0~6.

TOP/BOTTOM:

Set the Top/Bottom side of an area for the BLC to be adjusted. The value adjustable is 0~6.

HEIGHT:

Set the height of an area for the BLC to be adjusted. The value adjustable is 0~6.

Select “RET” to save all settings in this menu and returns to the previous menu. Select “END” to save all the menu settings and exit.

- 23 -

Image 24
Contents Operation Instructions Model No. ED610 Table of Contents White Balance Control DAY Night Main Features Content ListPage Specifications 3DNRWDR 12VDC/24VACDimensions 143mm//0.2 Ø 94.7mm/3.78Camera Component Description Exterior view Interior viewFront and Back Panel Layout Front Panel Layout Power & Video pigtail cable Test Video Output ConnectorExternal Light Sensor Focus RingSteps Mounting Camera 1 Drill the HolesMounting Ceiling Mount Wall Mount Adjusting Camera Adjusting Camera Position Adjusting Zoom and Focus Important Note when focusing a 9-22mm LensPage Camera Setting OSD User Setup Menu Close the Camera Cover after installation is completeCorrect Wrong not aligned OSD Menu & Configuration III. Switching to sub-menu screensReturn to previous Close the menu screenED610 Menu Tree Page Page Exposure ShutterAGC Auto Gain Control SENSE-UP4 BLC Hsblc WDRReturn White Balance Control DAY NightEXT 3DNRSpecial CAM TitleEffect 3.8.2.1 Freeze MirrorFlip RotateMotion Adjust PrivacySync LanguageReset Blue3 RED ExitMED6G00100