EverFocus EPN3600 user manual Event, Schedule

Page 69

EPN3600

Press Apply to apply the setting changes or Reset to reset without saving the change.

2.7EVENT

An event in the camera is when an Event Type is activated and causes certain actions to be performed. The event type is the set of conditions that specifies how and when which actions will be performed.

This table describes how to setup action types and event type.

Event Type

Alarm

Manual

Auto

Motion

Schedule

Pre/

Action Type

Input

Trigger

Tracking

Detection

Recording

Post-Alarm

Trigger Relay

x

x

x

x

 

 

Send Mail notification

x

x

x

x

 

 

Upload to FTP**

x

x

x

x

 

x

Record to PC*

x

x

x

x

x

x

Network Alarm

x

x

x

x

 

 

Re-trigger

x

x

x

x

 

 

Go to PTZ preset

x

Run Tour

x

Run Pattern

x

Note: 1. * Record to PC only works when PC and IP speed dome are connected.

2.**Either Upload to FTP or Record to Network Storage can be selected to record event video to remote site.

3.Up to 10 event types can be configured in the camera, and up to 3 of these can be configured to upload images.

69

Image 69
Contents User’s Manual EPN3600 About this document Safety NoticeSupport Terms and TrademarkTable of Contents 2.3.2 Introduction FeatureEPN3600 Default page of Camera Menu Accessing the Camera MenuVideo Stream View SizeRecord Snapshot ~ 10 Play Audio/Transmit AudioPTZ Control PTZ Control Window EPN3600 Auto Tracking -ON/OFF Number button, Go button and Clear buttonSelect Object Manual Control TriggerManual Control Reset Event signalsStatus Display Information System InfoSystem Info Information 2 LogText Setting User ConfigDate/Time Format Used in Text Recording/Snapshot Export SettingNetwork Network Network Setting- NetworkEPN3600 Ddns Ddns settingBandwidth Bandwidth SettingSet Smtp SMTP/FTPSet FTP Network Alarm reserved for PowerCon Set Network AlarmVideo Multi Streaming Stream SettingCamera Video Recording SettingSet Preset Position SettingsSet Auto Tracking Auto Mode Settings13 Video Camera -Auto Tracking Window How to set Auto Tracking Start pointSet Pan Range Set Pan/ Tilt LimitsSet Tilt Range 16 Pan Range Setting Right Limit Setting17 Tilt Range Setting Down Limit Setting Set tracking mask Clear Pan/ Clear Tilt20 Tracking Mask Size Window EPN3600 EPN3600 22 Set Object Size Max/Min frame Set Object SizeAlso click Reset button to make options to default values Set Auto Pan How to set Auto PanEPN3600 24 Video Camera -Tour Window Set Tour25 Video Camera -Pattern Window Set Pattern26 Video Camera -Set Pattern Recording Tour Seconds General Operation Guide of PTZ OSD Setting PTZ OSD SettingsButton/ button Exposure Video SettingsIris Mode 30 Video Settings Focus Mode Focus ModeWhite Balance Digital Zoom2.3.1.6 Day/Night Backlight34 PTZ Video Settings Day/Night Negative Color2.3.2 OSD/AREAS Wide Dynamic Range40 OSD/AREAS menu- Areas Sub-menu Areas41 Areas setting Left Position Setting Window Directions 43 Areas settingDefault North Set NorthDisplay Show OSD Zones Private Zones How to set private zoneTo adjust the size of private zone, use following buttons 53 Private Zone Zone Color Info Exit Audio56 Audio Audio57 User UserSchedule EventPress Button to add an event condition EventExample 1 Manual trigger-Upload to FTP Example 2 Alarm input Go to PTZ Preset with Auto-Tracking EPN3600 59 Event Event Tab Motion60 Event Alarm Tab Alarm61 Event Time Mask Time MaskDate/Time SystemEPN3600 63 System Daylight Saving Daylight Saving64 System Maintenance MaintenanceEPN3600 EKB200 65 EKB200 setting66 EKB200 Panel EPN3600 Specifications Audio Network / Interface EverFocus