EverFocus EAN800AW user manual Alarm

Page 33

EAN800A/EAN800AW

4.7.3 Alarm

Alarm Output Setting

Contact Type: Normal Close, Normal Open

Duration Time: Select duration time of alarm output from 5 sec, 10 sec, 20 sec, 30 sec, 60 sec, 2 min, 3 min and 5 min.

Press Apply to apply the setting changes or Reset to reset without saving the change.

Pre/Post Alarm Setting

This function is used to check what happened immediately before and after a trigger, e.g. 5 seconds before or after a motion has been detected.

Pre-Alarm Buffer: Image saved internally in the server from the time immediately preceding the trigger. Input the desired length of pre-trigger buffer time. It can be set up to 120 seconds.

Post-Alarm Buffer: Image saved internally in the server from the time immediately after the trigger. Input the desired length of post-trigger buffer time. It can be set up to 120 seconds.

Press Apply to apply the setting changes or Reset to reset without saving the change.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents EAN800A/EAN800AW EAN800A/EAN800AW About this document Safety NoticeTerms and Trademark SupportAbout AC Adaptor Table of Contents Introduction Accessing the Camera Menu EAN800A/EAN800AW EAN800A/EAN800AW Information System Info2 Log User Config EAN800A/EAN800AW Network NetworkIP address IP TypeSubnet Mask GatewayEAN800A/EAN800AW Secondary DNS PasswordUsername Http PortDdns Bandwidth SMTP/FTP EAN800A/EAN800AW Network Alarm reserved for PowerCon Wireless EAN800AW Multi Streaming VideoEAN800A/EAN800AW Camera Image settingEAN800A/EAN800AW Microphone is not available for U.S. region AudioUser Event EventEAN800A/EAN800AW EAN800A/EAN800AW Motion Alarm Time Mask Date/Time SystemEAN800A/EAN800AW Daylight Saving SD Card Indication Description Maintenance EAN800A/EAN800AW Specifications Environmental USA Office Head Office China OfficeEurope Office USA N.Y. Office
Top Page Image Contents