NAD S170 Safety Information, Explanation Of Graphical Symbols, Precautions, Installation

Page 2
SAFETY INFORMATION

SAFETY INFORMATION

GB

EXPLANATION OF GRAPHICAL SYMBOLS

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

PRECAUTIONS

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.

INSTALLATION

1Water and Moisture - Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like.

2Heat - Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41°F) or greater then 35°C (95°F).

3Mounting surface - Place the unit on a flat, even surface.

4Ventilation - The unit should be situated with adequate space around it so that proper ventilation is assured. allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from each side. - Do not place on a bed, rug, or similar surface that may block the ventilation openings. - Do not install the unit in a bookcase cabinet, or airtight rack where ventilation may be impeded.

5Objects and liquid entry - Take care that objects or liquids do not get inside the unit through the ventilation openings.

6Carts and stands - When placed or mounted on a stand or cart, the unit should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the unit and cart to overturn or fall.

7Condensation - Moisture may form on the CD pickup lens when:

•The unit is moved from a cold spot to a warm spot.

•The heating system has just been turned on.

•The unit is used in a very humid room.

•The unit is cooled by an air conditioner.

When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.

8Wall or ceiling mounting - The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions.

WARNING! TO REDUCE THE RISK OF FIRE OR ELECTRONIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE

This product is manufactured to comply with the radio interference requirements of EEC DIRECTIVE 89/68/EEC and 73/23/EEC

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents S170 AV Surround Sound Pre-amplifierPRECAUTIONS SAFETY INFORMATIONEXPLANATION OF GRAPHICAL SYMBOLS INSTALLATIONMAINTENANCE SAFETY INFORMATIONELECTRIC POWER DAMAGE REQUIRING SERVICETABLE OF CONTENTS TABLE OF CONTENTSGETTING THE MOST FROM THE NAD S170 SAVE THE PACKAGING UNPACKING AND SETUPWHATS IN THE BOX CHOOSING A LOCATIONABOUT THX ABOUT THE S170E.A.R.S EASE OF USEUPGRADABILITY ABOUT THE S70 SYSTEM REMOTE CONTROLABOUT THE S170 QUICKSTART PLAY A DVD MOVIE OR MUSIC CDFRONT PANEL REAR PANEL COMPOSITE VIDEO OUT 4-6OUT MON OUT Connect toGETTING STARTED SETTING UP THE S170USING THE S70 REMOTE DEALING WITH HUM AND NOISENOTE THAT DISPLAYING THE MENUSNAVIGATING THE OSD AND MAKING CHANGES NOTE THAT CONFIGURING THE S170DISPLAY SETUP THX DEFAULT CONFIGURING THE S170AUDIO SETUP BASS/TREBLEPRESET SETUP CONFIGURING THE S170CONFIGURING THE BASS LIMITER CONFIGURING PRESETSCONFIGURING SPEAKERS CONFIGURING THE S170SPEAKER SETUP LEVEL SETUPDELAY SETUP CONFIGURING THE S170CONFIGURING LEVELS CONFIGURING DELAYSCONFIGURING THE S170 TRIGGER SETUPSELECTING SOURCES USING THE S170ADJUSTING THE VOLUME NOTE THATABOUT THE S170S LISTENING MODES USING THE S170SETTING LISTENING MODES MONOANALOG BYPASS USING THE S170EARS 2-ch.PCMReadout/OSD USING THE S170Source SELECTING LISTENING MODESABOUT THE LATE NIGHT MODE USING THE S170ADJUSTING CHANNEL LEVELS NOTE THATUSING PRESETS USING THE S170ADJUSTING THE TONE CONTROLS NOTE THATNOTE THAT USING THE S170FRONT PANEL OPERATIONS LISTENING IN A REMOTE ZONE MULTISOURCE USING THE S170CONTROLLING MULTISOURCE VOLUME NOTE THATNOTE THAT SAFETY INFORMATIONNAD LINK SYSTEM INTEGRATION RS-232TO FRONT-PANELCOMMANDS SPECIFICATIONSPOSSIBLE SOLUTIONSS CONDITIONSTEREO ANALOG BYPASS SPECIFICATIONSPHYSICAL SPECIFICATIONS OUTPUT IMPEDANCENew HTR 2 Learning Remote Control New V3.03 Operating System SoftwarePage 2001 NAD ELECTRONICS INTERNATIONAL
Top Page Image Contents