NAD owner manual USING THE S170, Front Panel Operations, Note That

Page 26
FRONT PANEL OPERATIONS

USING THE S170

GB

FRONT PANEL OPERATIONS

It is possible to perform every function directly from the S170 Preamplifier's front panel, without the S70 remote controller.

•To change input sources or listening modes, press AUDIO or Video or MODE; the VOLUME (SETUP) knob will now cycle, bi-directionally, through all audio-video or audio-only sources, or listening modes. The source or mode names appear on the OSD as well as the front-panel readout. After five seconds of inactivity, the display and the knob will return to their normal functions.

•Press TAPE MONITOR to hear the component or signal connected to the rear-panel TAPE MONITOR IN/OUT jacks; press Tape MONITOR again to bypass the tape monitor loop. <Tape Monitor On> and <Tape Monitor Off> appears on the OSD.

•To adjust the treble, press TONE once and use the VOLUME (SETUP) knob to raise or lower the setting; press TONE a second time to adjust bass; the new tone settings appear on both the OSD and the front- panel readout. Press TONE a third time to return the readout and VOLUME (SETUP) knob to their normal functions.

•Press BRIGHTNESS once to dim the front-panel readout, press the key again to return the readout to its normal brightness.

•The SPEAKERS key accesses the same functions as the <Speaker setup> OSD menu (see Speaker Setup, above). The OSD will not appear, but the necessary information will display on the front-panel readout. Each subsequent press of SPEAKERS moves through Main, Center, Surround, Back, and Subwoofer options; while any is selected the VOLUME (SETUP) knob cycles bi-directionally through the available options, such as "No/Small/Large" for the Center position. Press the SPEAKERS key one more time (beyond Subwoofer) to return the readout and knob to their normal functions.

•The DELAY key works similarly, adjusting channel-delays for each channel present. See the paragraph directly above.

•The LEVELS key works similarly, adjusting channel-levels for each channel present. See the paragraphs directly above.

•You can adjust the remote room's audio using the MULTISOURCE key. Press MULTISOURCE once to adjust remote-room volume using the VOLUME (SETUP) knob; press MULTISOURCE a second time to cycle the source sent to the REMOTE ROOM rear-panel jacks through the audio-only sources using the VOLUME (SETUP) knob, bi-directionally. Press MULTISOURCE a third time to return the readout and knob to their normal functions; the normal functions will also return automatically after five seconds of inactivity.

NOTE THAT:

Mute, THX, LateNight, Standby and Presets can't be accessed from the front panel.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents S170 AV Surround Sound Pre-amplifierPRECAUTIONS SAFETY INFORMATIONEXPLANATION OF GRAPHICAL SYMBOLS INSTALLATIONMAINTENANCE SAFETY INFORMATIONELECTRIC POWER DAMAGE REQUIRING SERVICETABLE OF CONTENTS TABLE OF CONTENTSGETTING THE MOST FROM THE NAD S170 SAVE THE PACKAGING UNPACKING AND SETUPWHATS IN THE BOX CHOOSING A LOCATIONABOUT THX ABOUT THE S170E.A.R.S EASE OF USEUPGRADABILITY ABOUT THE S70 SYSTEM REMOTE CONTROLABOUT THE S170 QUICKSTART PLAY A DVD MOVIE OR MUSIC CDFRONT PANEL REAR PANEL COMPOSITE VIDEO OUT 4-6OUT MON OUT Connect toGETTING STARTED SETTING UP THE S170USING THE S70 REMOTE DEALING WITH HUM AND NOISENOTE THAT DISPLAYING THE MENUSNAVIGATING THE OSD AND MAKING CHANGES NOTE THAT CONFIGURING THE S170DISPLAY SETUP THX DEFAULT CONFIGURING THE S170AUDIO SETUP BASS/TREBLEPRESET SETUP CONFIGURING THE S170CONFIGURING THE BASS LIMITER CONFIGURING PRESETSCONFIGURING SPEAKERS CONFIGURING THE S170SPEAKER SETUP LEVEL SETUPDELAY SETUP CONFIGURING THE S170CONFIGURING LEVELS CONFIGURING DELAYSCONFIGURING THE S170 TRIGGER SETUPSELECTING SOURCES USING THE S170ADJUSTING THE VOLUME NOTE THATABOUT THE S170S LISTENING MODES USING THE S170SETTING LISTENING MODES MONOANALOG BYPASS USING THE S170EARS 2-ch.PCMReadout/OSD USING THE S170Source SELECTING LISTENING MODESABOUT THE LATE NIGHT MODE USING THE S170ADJUSTING CHANNEL LEVELS NOTE THATUSING PRESETS USING THE S170ADJUSTING THE TONE CONTROLS NOTE THATNOTE THAT USING THE S170FRONT PANEL OPERATIONS LISTENING IN A REMOTE ZONE MULTISOURCE USING THE S170CONTROLLING MULTISOURCE VOLUME NOTE THATNOTE THAT SAFETY INFORMATIONNAD LINK SYSTEM INTEGRATION RS-232TO FRONT-PANELCOMMANDS SPECIFICATIONSPOSSIBLE SOLUTIONSS CONDITIONSTEREO ANALOG BYPASS SPECIFICATIONSPHYSICAL SPECIFICATIONS OUTPUT IMPEDANCENew HTR 2 Learning Remote Control New V3.03 Operating System SoftwarePage 2001 NAD ELECTRONICS INTERNATIONAL
Top Page Image Contents