FujiFilm 30i manual Disposing of Batteries, Ni-MH batteries

Notes on the Power Supply

Applicable Batteries

hUse AA-size nickel-metal hydride (Ni-MH) batteries in this camera.

AA-size lithium or manganese batteries cannot be used as they emit heat and can cause camera faults or damage.

hOnly use AA-size alkaline batteries for emergencies. The capacities of alkaline batteries vary depending on the brand and the life of some batteries (the time for which they provide power) may be much shorter than others. You should also switch the LCD monitor off when using alkaline batteries.

Notes on the Batteries

Incorrect use of the batteries could cause them to leak, become hot, ignite or burst. Always observe the precautions given below.

hDo not heat the batteries or throw them into a fire.

hDo not carry or store batteries with metal objects such as necklaces or hairpins that could come into contact with the metal positive ! and negative @ poles of the batteries.

hDo not expose the batteries to fresh or sea water, and take particular care to keep the terminals dry.

hDo not attempt to deform, disassemble or modify the batteries.

hDo not attempt to peel off or cut the batteries casing.

hDo not drop, strike or otherwise subject the batteries to strong impacts.

94 hDo not use batteries that are leaking, deformed,

discolored or exhibit any other obvious abnormality. hDo not store batteries in very warm or moist locations.

hKeep the batteries out of the reach of babies and small children.

hWhen loading the batteries in the camera, ensure that the battery polarity (!and @) is as indicated on the camera.

hDo not use a new battery together with an used battery. In the case of rechargeable batteries, do not use charged and discharged batteries together. Do not use batteries of different types or brands together.

hIf you do not intend to use the camera for a long period of time, remove the batteries from the camera. (Note that if the camera is left with the batteries removed, the time and date settings are cleared.)

hThe batteries may feel warm immediately after being used. Before removing the batteries, switch the camera off and wait until the batteries cool down.

hWhen replacing the batteries, always fit 2 new batteries. Here, “new batteries” refers to batteries that were recently fully charged at the same time.

hBattery performance deteriorates at low temperatures (+10°C/+50°F or below) and the time for which they can be used shortens. This is particularly true of alkaline batteries. In cold conditions, put the batteries in your pocket or a similar place to warm them before loading them into the camera. If you use a body warmer to warm the batteries, ensure that they are not in direct contact with the warmer.

hSoil, such as fingerprints, on the battery terminals can significantly reduce the number of available shots. Carefully wipe the battery terminals clean with a soft, dry cloth before loading the batteries.

If any liquid at all leaks from the batteries, wipe the battery compartment thoroughly and then load new batteries.

If any battery fluid comes into contact with your hands or clothing, flush the area thoroughly with water. Note that battery fluid can cause loss of eyesight if it gets in your eyes. If this occurs, do not rub your eyes. Flush the fluid out with clean water and contact your physician for treatment.

■Disposing of Batteries

When disposing of batteries, do so in accordance with your local waste disposal regulations.

■Notes on using compact rechargeable batteries

(Ni-MH batteries)

hTo charge AA-size Ni-MH batteries, follow the correct charging procedure using the special charger provided or the optional fast charger.

hDo not use the battery charger to charge batteries other than those specified for use with the charger.

hNote that the batteries may feel warm immediately after being charged.

hNi-MH batteries are not charged at shipment.

hThe camera mechanism is such that it draws a minute amount of current even when the camera is switched off. Note particularly that Ni-MH batteries will become over- discharged if left in the camera for a long period and will no longer be usable even if recharged.

hNi-MH batteries self-discharge even when they are not being used. Always charge Ni-MH and Ni-Cd batteries before using them. If the time for which a battery provides power shortens markedly when it has been correctly

charged, this indicates that the battery has reached the end of its effective life and should be replaced.

hSoil (fingerprints, etc) on the terminals of Ni-MH batteries can greatly reduce the number of available shots. When this occurs, clean the terminals carefully with a soft dry cloth. Then use up the remaining charge in the batteries and recharge them.

hNewly purchased batteries or batteries that have been left unused for an extended period may not be fully charged. (This is indicated by the immediate display of the battery low warning and a low available shots/time for battery operation.) This is a normal characteristic of the batteries and does not indicate a fault. Repeatedly charging and using the batteries 3 or 4 times will enable you to fully recharge the batteries and increase the time for which the camera will operate using batteries.

hIf you repeatedly charge a Ni-MH batteries before it is fully discharged, it will suffer from the “memory effect”✽, causing the “battery low” warning to appear while there is still ample charge remaining in the battery. To restore the batteries to their normal condition, use up all the charge in the batteries before recharging them.

✽Memory effect: A phenomenon whereby a battery displays the characteristic of appearing to have a reduced capacity.

Notes on Using the Enclosed Battery Charger

hRechargeable batteries and the battery charger itself will become warm due to the power stored inside the batteries. This is normal and does not indicate a fault. 95