SmartMedia with IDs, Storing Data

FujiFilm 30i manual SmartMedia with IDs, Storing Data

Notes on the Power Supply

Notes on the SmartMedia™

Wherever possible, use the battery charger in a well- ventilated location.

hThere may be vibration noises from inside the battery charger during use. This is normal and does not indicate a fault.

hDo not use the battery charger to charge batteries other than FUJIFILM HR-3UF Ni-MH batteries.

hThe battery charger could cause interference if placed close to a radio during charging. In this event, move the radio and charger further apart.

hDo not touch the connections or contact points on rechargeable batteries with other metal objects as this can cause a short circuit.

hDo not leave the battery charger in the following locations: Locations subject to strong vibrations, in very dusty locations, or in locations with very high humidity or high temperatures, such as close to a heating appliance or in direct sunlight.

hThe battery charger accepts input voltages of 100-240 V AC at 50 or 60 Hz and can be used outside Japan. However, because the shapes of power sockets vary by country and by region, an appropriate plug adapter is also required for each country. Consult your travel agent for details.

Specifications of the Enclosed Battery Charger BC-NHS

Rated input		100-240 V AC, 50/60 Hz
Input capacity		0.04 A-0.07 A
96 Rated output		1.2 V DC, 400 mA ⋅ 2
96 Rated output		1.2 V DC, 400 mA ⋅ 2

Applicable	FUJIFILM HR-3UF
batteries	(Ni-MH: 1500 mAh, 1600 mAh or 1700 mAh)
Charging	HR-3UF (1500 mAh): Approx. 3.8 hours
time	HR-3UF (1600 mAh): Approx. 4.5 hours
	HR-3UF (1700 mAh): Approx. 5 hours
Dimensions	68 mm ⋅ 90 mm ⋅ 26.5 mm
	(2.7 in. ⋅ 3.55 in. ⋅ 1.05 in.) (W ⋅ H ⋅ D)
Mass (Weight)	Approx. 85 g (3.0 oz.) (excluding batteries)
Operating	0°C to + 40°C (+ 32°F to + 104°F)
temperatures

Notes on Using the AC Power Adapter

Always use the AC-3V AC Power Adapter (sold separately) with the FinePix30i.

The use of an AC power adapter other than the AC-3V could result in damage to your camera.

hEnsure that you do not touch the contact areas on the AC power adapter against any other metal object as this could cause a short circuit.

hDo not plug in the AC power adapter while you are operating the camera using batteries. Switch the camera off first.

hDo not load the batteries while you are operating the camera using the AC power adapter. Switch the camera off first.

hIf you disconnect the AC power adapter when there are no batteries in the camera, the date and time settings will be lost and must be reset.

■SmartMedia

The SmartMedia card supplied with your FinePix30i camera is a new image recording medium developed especially for use in digital cameras. Each SmartMedia card contains a built-in semiconductor memory chip (NAND flash memory) which is used for storing digital image data.

Because the data is stored electronically, the stored image data can be erased from the card and new data recorded.

■SmartMedia with IDs

The SmartMedia ID is a SmartMedia that has an individually assigned identification number. SmartMedia ID cards can be used with devices that use ID numbers for copyright protection or other purposes. This camera accepts SmartMedia ID cards in the same way as conventional SmartMedia cards.

■Storing Data

In the situations listed below, recorded data may be erased (destroyed). Please note that Fuji Photo Film Co., Ltd. accepts no responsibility whatsoever for the loss (destruction) of recorded data.

✽When the SmartMedia is used incorrectly by the owner or a third party

✽When the SmartMedia is exposed to static electricity or electrical noise

✽When the battery cover is opened or the SmartMedia removed and the camera is then switched off during data recording, during data erasing (SmartMedia formatting) or during frame advance when images are being played back.

Back up important data onto another medium. (MO disk, floppy disk, hard disk, etc.)

■Notes on Handling SmartMedia

hTake care to hold the SmartMedia straight when you load it into your camera.

hNever remove the SmartMedia or switch the camera off during data recording, during data erasing (SmartMedia formatting) or during frame advance when images are being played back. These actions could result in damage to the SmartMedia.

hUse only the SmartMedia specified for use with the FinePix30i. The use of other SmartMedia could damage the camera.

hSmartMedia are precision electronic devices. Do not bend, drop, or subject SmartMedia to excessive shocks.

hDo not use or store SmartMedia in environments likely to be affected by strong static electricity or electrical noise.

hDo not use or store SmartMedia in very hot, humid or corrosive environments.

hTake care not to touch the SmartMedia’s contact area or allow the area to become soiled. Use a dry lint-free cloth to wipe away any soiling that does occur.

hTo avoid damage caused by static electricity, always use the special static-free case provided during transportation or storage, or keep the SmartMedia in a storage case if available.