D-Link DCS-1000W manual Input 1 Trigger, Input 2 Trigger

The default setting for the I/O Trigger functions is “disabled.” You must enable the I/O Trigger first before the Triggers will perform.

There are two options to select from the Trigger screen I/O Input 1 Trigger and I/O Input 2 Trigger.

I/O Input 1 Trigger:

Select “Send e-mail attached with image” and enter the relevant information such as the SMTP Server Address, Sender e-mail Address, Receiver e-mail Address, Sending Interval and Sending Times.

™SMTP (Simple Mail Transfer Protocol) is a protocol for sending e-mail messages between servers. You need to input the mail server address in this field.

™Sender e-mailis the person’s e-mail address that will be sending the e-mail.

™Receiver e-mailis the e-mail address of the person that will receive the e-mail.

™Sending Interval is the period of time between each e-mail being sent to the receiver. If the setting is at 10 seconds, a new e-mail will be sent in 10 seconds interval to the receiver.

™Sending Time is the number of times the e-mail will be sent to the receiver before it terminates.

Select “Trigger I/O Output” and enter the setting for the duration of the output device for Output 1 time and Output 2 time in seconds.

I/O Input 2 Trigger:

Refer to “I/O Input 1 Trigger” information above.

Save/Cancel:

After making sure all settings in the System are correct, click on the “Save” icon to store the settings for the Internet Camera. You can alternatively click on the “Cancel” icon to restore all settings to the values last saved to or retrieved from the Internet Camera.

Warning

When connecting other devices through the I/O connectors, please make sure the maximum current of 100mA is strictly observed. Any failure to do so might cause a loss of power and possibly cause serious damage to the Internet Camera.

Please refer to the appendix for detailed information regarding the I/O Connector.

29