- Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the default values (shaded). Any edited scenes will be lost.
1.Select “LODA” by pressing [UP] or [DOWN] button.
2.Press [ENTER], the display shows “ON” or “OFF”.
3.Press [UP] to select “ON” if you wish to enable this function or press [DOWN] button to “OFF” if you don’t.
4.Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Software version
With this function you can display the software version of the device.
1.Select “VER” by pressing [UP] or [DOWN] button.
2.Press [ENTER], The display will show
3.Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Main menu 3
1.Press [MODE/ESC] to enter the main menu (display flashing).
2.Press [UP] or [DOWN] button to select “ADJU”.
- Lamp adjustment
With this function you can adjust the lamp via the Control Board. The shutter opens and the lamp can be adjusted. In this mode, the device will not react to any control signal.
1.Select “LADJ” by pressing [UP] or [DOWN] button.
2.Press [ENTER], the display shows “ON” or “OFF”.
3.Press [UP] to select “ON” if you wish to enable this function or press [DOWN] button to select “OFF” if you don’t.
4.Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Test function of each channel
With this function you can test each channel on its (correct) function.
1.Select “TEST” by pressing [UP] button.
2.Press [ENTER], the display shows
3.The current channel will be tested.
4.Select the desired channel by pressing [UP] or [DOWN] button.
5.Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
15 DESIGN WASH 250 USER MANUAL V1.0 NR