DATA-TRANSFER MODE
CONNECTING THE CAMERA TO A COMPUTER
A fresh set of batteries should be used when the camera is connected to a computer. The use of the AC adapter (sold separately) is recommended over the use of batteries. For users with Windows 98 and Mac OS 8.6, read the respective sections on how to connect to the operating system before connecting the camera to a computer (Windows 98 - p. 126, OS 8.6 - p. 129).
1
6After using the
•“Enter” should appear on the right side of the screen.
7Press the center of the controller to send a signal to the computer to initiate the USB connection.
•A screen will appear to indicate the beginning of the connection process.
•When the signal has been received by the computer, the camera’s monitors will turn off.
Trans
USB
USBEnter
Initializing USB connection
2
3
4 Open the
• Make sure the plug is firmly attached.
5Attach the other end of the USB cable to the computer’s USB port.
•Make sure the plug is firmly attached.
•The camera should be connected directly to the computer’s USB
port. Attaching the camera to a USB hub may prevent the camera from operating properly.
4
COMPUTER
5
When the camera is properly connected to the computer, a drive icon will appear. If the computer does not recognize the camera, disconnect the camera and restart the com- puter. Repeat the connection procedure above.
124 | 125 |