Olympus TG-320 After Use, Closing Battery/card/connector cover, Storage and Maintenance

After Use:

•Be sure to wipe off any excess water or debris after using the camera under water.

•After the camera is used under seawater, immerse the camera in a bucket containing fresh water for about 10 minutes (with the battery/card/connector cover firmly closed). After that, dry the camera in the shade with good ventilation.

•Water drops may be observed on the inner surface of the battery/card/connector cover after you open the cover. If any water drops are found, be sure to wipe them off before using the camera.

Notes after use

•Foreign materials may be attached to the camera when using the camera in conditions with foreign materials such as dirt, dust or sand. If you continue to use the camera in such conditions, it could cause damage to the camera. To avoid such damage, wash the camera using the following method.

1Insert the battery and close the battery/card/ connector cover firmly so that lock makes the clicking sound.

2Fill a bucket or other container with fresh water, immerse the camera facing downward in the bucket and shake the camera thoroughly. Or rinse the camera by placing it directly under a strong stream of tap water.

•Do not leave the camera in water for a long time. Prolonged exposure to water will cause damage to the camera’s appearance and/or deteriorate water resistance.

•In order to preserve the water resistant feature, as with any underwater housing, it is recommended that the waterproof packing (and seals) are replaced annually.

For the Olympus distributors or service stations where the waterproof packing can be replaced, visit Olympus website for your local area.

Closing Battery/card/connector cover

Battery/card/connector cover

The included accessories (e.g. USB-AC adapter) do not offer shock or water resistance.

Storage and Maintenance

•Do not leave the camera in an environment at high temperature (40°C (104°F) or more) or at low temperature (-10°C (14°F) or less). Failure to do so may break down water resistance.

•Do not use chemicals for cleaning, rust prevention, anti- fogging, repairing, etc. Failure to do so may break down water resistance.

EN 69