Light & Motion TITAN D100 manual Front Controls, Left Smart Grip Fig, Right Smart Grip Fig

Page 6

Front Controls

Shutter Lever:Accesses the camera’s shutter button (Fig. 27).

The Shutter Lever also activates the camera’s auto focus when depressed half way.When depressed fully, the camera will take a photo.

Focus Mode Selector (Fig. 28): Selects camera’s focus mode.

Left Smart Grip (Fig. 29)

(Fig. 17)

 

(Fig. 18)

 

 

 

 

 

 

 

 

Main + button: Increases shutter speed in M and S shooting modes.

 

 

 

 

Main - button: Decreases shutter speed in M and S shooting modes.

 

 

 

 

 

 

 

 

The Main + / - buttons perform all main command dial functions.

 

 

 

 

L ~ R OFF: Selects strobe control mode and deactivates strobes.

 

 

 

 

Strobe power can be controlled independently from the respective side handle or

 

 

 

 

strobe power can be controlled together from either handle.

 

 

 

 

To control strobes independently, press the button until the ROC LEDs blink separately.

 

 

 

 

Strobe power level is controlled by the handle on the same side.

 

 

 

 

To adjust strobe power together, press the button until both LEDs blink together. Either

 

 

 

 

(Fig. 19)

 

(Fig. 20)

handle then controls power level for both strobes.

 

 

 

 

To deactivate strobes, press and hold button until Strobe OFF LEDs illuminate.

 

 

 

 

To reactivate strobes, press and release button.

 

 

 

 

~

+ and~

- buttons: Left strobe increase or decrease power buttons.

 

 

 

 

Right Smart Grip (Fig. 30)

 

 

 

 

 

Sub + button: Increases f/stop in M and A shooting modes.

 

 

 

 

Sub - button: decreases f/stop in M and A shooting modes.

 

 

 

 

The Sub + / - buttons perform all sub command dial functions.

(Fig. 21)

 

(Fig. 22)

 

 

 

 

 

 

 

 

 

~

+ and ~

- buttons: Right strobe increase or decrease power buttons.

 

 

 

 

Focus button: Pressing this button is just like pressing the shutter button half way.

 

 

 

 

 

 

 

 

Activates electronic auto focus (half shutter).

 

 

 

 

Press and hold the Focus button to keep the camera’s focus locked.

 

 

 

 

While holding the Focus button down, pull the shutter release to take a photo.

 

 

 

 

Focus button will not function if the Battery Board is not installed.

 

 

 

 

Also see page 18 to use the AEL/AFL feature of this button.

 

 

 

 

 

 

 

 

(Fig. 23)

(Fig. 24)

Image 6
Contents Standard Warranty Fault Free Warranty OptionalTable of Contents WelcomeFirst Time Use Battery BoardGetting Started Camera PreparationInstalling the D100 Battery BoardRear Plate Controls Titan D100 ControlsTop Controls Left Side ControlsFront Controls Left Smart Grip FigRight Smart Grip Fig Attaching Sync Cables to Titan Installing BulkheadsAttaching Strobes Nikonos StylePre-Dive Checklist ROC and Focus ControlsUsing ROC for strobe control Using ROC for AE-L / AF-LChanging D100 Lenses Attaching Light & Motion Ports / Conversion RingsAttaching Light & Motion Lens gears Installing the Pointer Light Optional Installing Mod LightInstalling Sunray Mod Light Optional Then snap Mod Light and arm assembly on the base FigMoisture Alarm Replacing Handle Thread RingsRemove housing from rinse tank and then simply towel dry Ring Care and MaintenanceTitan D100 Accessories After Diving CareReturning Products for Care Contact Light and MotionSales Department