Light & Motion TITAN D100 manual Using ROC for strobe control, Using ROC for AE-L / AF-L

(Fig. 33) (Fig. 34)

Using ROC for strobe control

The default strobe control settings for ROC has the strobes being controlled independently from the respective handle. ROC will revert to this setting every time it enters the OFF state or when the camera is removed from the tray and ROC loses power. ROC will always retain the last programmed strobe profile even when power is removed.

1.	Turn strobe(s) on and in the TTL position.
2.	Press the +/- buttons on the respective handles to adjust strobe power (Fig. 40).
	To adjust strobe power levels together, press the L/R Strobe button and watch for power
	LEDs to blink together. Then press the +/- button from either handle to adjust strobe
	power for both strobes (Fig. 41).
	To return to adjusting the strobe power levels independently, press the L/R Strobe button
	and watch for the power LEDs to blink separately. Then press the +/- button from the

+

LR

OFF

Press together and hold

to enter programming mode.

(Fig. 35)

+

LR

OFF

Press strobe select button to adjust LEDs together or independently.

(Fig. 37)

+

LR

OFF

Press together and hold to save strobe profile.

+

LR

OFF

Press either button to move ROC LED position.

(Fig. 36)

F = Empty

–= Ikelite 400 -1 = Ikelite 200

–= Ikelite DS-125 -2 = Ikelite 100

–= Ikelite DS-50/50 -3 = Nikonos SB-105

–= Nikonos SB-104

-4 = Sea & Sea YS-350/300

-5 = Sea & Sea YS-120

-6 = Sea & Sea YS-90DX/90/60/50

-7 = Sea & Sea YS-30

(Fig. 38)

respective handle to adjust that side strobe power.

3. Press the + button to increase the strobe’s power or the - button to decrease the

strobe’s power.

To deactivate the strobe from firing, press and hold the L ~ R Strobe button on the left handle until the Strobe Off LEDs illuminate (Fig. 42). Press and release the L ~ R button to re-activate strobes.

Using ROC for AE-L / AF-L

The default setting for the Focus button is half-shutter. Pressing this button is the same as pressing the camera’s shutter release half-way. The Focus button can also be reporogrammed to be the camera’s AE-L / AF-L button.While in this mode pressing the handle’s Focus button is the same as pressing the AE-L / AF-L button on the camera.

This is a two step process and will change the default, half shutter, function of the Focus button to the AE-L / AF-L function.

1.Press and hold both the Sub + and Strobe + on the right handle (Fig. 43).

The handle LED should blink 4 times indicating the Focus button switching to Focus lock function (Fig. 44).

2.Enter the camera’s menu and select the CSM menu. In the CSM menu scroll to sub-menu 14 and enter. In this sub-menu change the setting to “AF ON” (Fig 45) or whichever optoin you prefer.

To use the auto focus lock, press the Focus button. The camera will auto focus and continue to refocus as long as the button is held down. When the camera is focused at the appropriate distance, release the Focus button.

The camera will keep focus locked at the same distance until the Focus button is pressed again.Then the camera will readjust the focus distance.

To return the Focus button to half-shutter return the menu focus setting to its prior setting and press the Sub + and Strobe + buttons until the handle LED blinks twice.

(Fig. 39)