3UREOHP | &DXVH | 6ROXWLRQ |
|
|
|
Picture is too dark. | Flash is not on or | Turn on the flash. Refer to “Flash” in |
| did not go off. | Chapter 3. |
| The subject is too | Move so there is no more than 10 ft (3 m) |
| far away from the | between the camera and the subject. |
| flash. |
|
| The subject is in | Change your position so the light is not |
| front of a bright | behind the subject. |
| light. |
|
|
|
|
Picture is too light. | The flash is not | Change to automatic flash. Refer to |
| needed. | “Flash” in Chapter 3. |
| The subject was too | Move so there is at least 1.6 ft (0.5 m) |
| close when you | between the camera and the subject. |
| used the flash. |
|
| The light sensor is | Hold the camera so your hands or other |
| covered. | objects do not cover the light sensor. |
|
|
|
Stored pictures are | The memory card | Make sure the Ready light is not blink- |
damaged. | was removed when | ing before removing the memory card. |
| the Ready light was |
|
| blinking. |
|
Pictures remaining | The image resolu- |
number does not | tion does not take |
decrease. | up sufficient space |
| to decrease the pic- |
| ture remaining |
| number. |
The camera is operating normally. Con- tinue taking pictures.
Picture is not clear. | The lens is dirty. | Clean the lens. Refer to “Caring for the |
|
| Camera” in Chapter 2. |
The subject was too close when you took the picture.
Move so that there is at least 1.6 ft (0.5 m) between the camera and the subject. Stand at least 8 in (20 cm) away for
| Subject or camera | Hold camera steady during picture tak- |
| moved during pic- | ing until after the flash (or the second |
| ture taking. | flash if the camera flash is set for red- |
|
| eye reduction). |
|
|
|
Templates do not | The memory card | Only the original memory card contains |
work. | may not contain the | templates. Templates are lost when the |
| templates. | memory card is formatted. Instructions |
|
| for replacing the templates can be |
|
| found on the Kodak Web site at |
|
| www.kodak.com. |
|
|
|
Troubleshooting