Setting Up Functions Before Taking Pictures
Setting An Image At Protect Status (Preset : Unlock)
To set an image at protect status can prevent the selected image from being erasing.
1.Select "Protect".
2.Select "Lock" to protect the selected image.
3.Press Right Direction Button ( 
) to confirm the setting.
Note
After the above steps are done, please check if the (
) is shown on the right
side of the TFT LCD screen. If it is not shown please repeat the above steps.
Cancelling The Protection Of An Protect Image
1.Select "Protect".
2.Select "Unlock" to cancel the protection.
3.Press Right Direction Button ( 
) to confirm the setting.
Printing Out An Image With A Printer Without Going Through PC (Preset : X0)
Please set the Mode Dial at Playback Mode ( 
) and press Menu
Button to enter "Play" menu table. Use Up Direction Button ( 
)
and Down Direction Button ( 
) to move the color bar to the option you would like to set up.
1.Select "Print ".
2.Select the number of copies you would like to print out from X0 to X9. The number means the number of the copies you would like to print out.
3.Take out the memory card from the camera and put it into the card reader slot of the printer.
4.Set the printer at DPOF Print and then the printer will print out the selected image(s) according to the number(s) you set.
5.Press Right Direction Button ( 
) to confirm the setting or select Menu Button to cancel the setting.
Note
After the above steps are done, please check if the ( 
) is shown on the left down corner. If it is not shown, please repeat the steps.
Note
This function can only work with a memory card, not with the
26
Setting Up Functions Before Taking Pictures
Under Movie Clip Mode( 
) (Preset : 10 Seconds )
Please set the Mode Dial at Movie Clip Mode( 
) .
Setting Up Recording Time
1.Select the time for the movie clip,"10 seconds, 20 seconds, 30 seconds" or "Manual".
2.Press Right Direction Button ( 
) to confirm the setting.
3.Press Shutter Button to start recording.
Note
1.In spite of selecting 10, 20 or 30 seconds, press the Shutter Button and the camera will start the recording and stop automatically according to the time you select.
2.If "Manual" is selected, press the Shutter Button to start the recording or press the Shutter Button again to stop the recording.
Note
The TFT LCD Monitor will show "Low Light!" as a warning to remind you that the video that you are going to record is in a low light environment.
Under Setup Mode( 
)
Please set the Mode Dial at Setup Mode ( 
). Use Up Direction
Button ( 
) and Down Direction Button ( 
) to move the color bar to the feature you would like to set up. Press Right Direction
Button( 
) to enter the setting and select your preferred setting
using Up ( 
) and Down ( 
) Direction Buttons. Press Right
Direction Button ( 
) to confirm the new setting or press Menu button to cancel the setting. When the LCD Display is back to the "Setup" menu table, please check if the new setting is shown on the right side of the LCD screen. If the new setting is not shown please repeat the above procedure.
27