Konica Minolta KD-25 user manual Taking Pictures, Playback / Erasing, Viewing a Part Of An Image

Page 16

Taking Pictures

1.Switch on the power bySafetysliding Notesthe Power Switch to the side, holding it for 1 second, and letting it go.

2.Set the Mode Dial at Shooting Mode ( ) for still image

capture or Movie Clip Mode ( ) for videos.

3.If you would like to capture a still image, please set the focus switch at correct focus range which are:

Macro ( ): 0.18m~0.25m

Portrait ( ): 0.8m~1.3m

Normal ( ): 1.3m~infinity

4.Set up all the preferred features and functions.

5.Hold still and press the Shutter Button.

6.The LED Indicator will start blinking after the Shutter Button is released. After the LED Indicator stops blinking, then you are able to take another shot.

Note

The TFT LCD Monitor will show "Low Light!" as a warning to remind you that the image that you are going to capture is under a low light environment. It is suggested to set the Flash Mode at Auto Flash or Fill-in Flash for supplementary light to compose a good image.

30

Playback / Erasing

Viewing A Part Of An Image

Set the Mode Dial at Playback Mode ( ). The TFT LCD Monitor will show the latest captured image.

1.Press Right Direction Button ( ).

2.Press Up Direction Button ( ) to adjust the size of the image.

3.Press Right Direction Button ( ) again to enter.

4.Use four direction buttons to view the image.

5.Press Menu Button to cancel this function.

Showing The Information Of A Still Image

Please set the Mode Dial at Playback Mode ( ) . The TFT LCD

Monitor will show the latest capture image. Use Up ( ) and

Down ( ) Direction Buttons to select other captured images.

1.Select an image.

2.Press LCD Button to show the information.

3.Press LCD Button again to erase the information.

31

Image 16
Contents Digital Still Camera Table Of Contents Important Safety Precautions Getting StartedDo not dismantle, modify or repair the camera yourself Important Safety Precautions Introduction Back Exposure Protected Image Print Dpof Preparation For Taking PicturesPreparation For Taking Pictures Preparation For Taking Pictures Setting Up Functions Before Taking Pictures Setting Up Focus RangeSetting Up Functions Before Taking Pictures Setting Up Image Quality Preset Fine qualitySetting Up White Balance Preset Auto White Balance Setting Up Exposure Preset +0Formatting An SD CardSafety Notes Setting Up Slide Show Preset 1 secondCancelling The Protection Of An Protect Image Setting An Image At Protect Status Preset UnlockSetting Up Recording Time Setting Up Beep SoundSafetyPreset NotesOn Setting Up Auto Power Off Preset 2 MinutesSetting Date Stamp Preset On Setting Date TypeTaking Pictures Playback / ErasingViewing a Part Of An Image Showing The Information Of a Still ImageInstalling Camera Driver Playing a Recorded Movie ClipGoing Into Thumbnail Images Small Images Deleting ImagesInstalling Camera Driver Please click OK to restart the PC Installing Camera Driver Installing Camera Driver Installing Ulead Photo Explorer Installing Ulead Photo Explorer Installing Ulead Photo Explorer Installing Ulead Photo Explorer Installing Ulead Photo Explorer About Ulead Photo Explorer Software licenseLicenses and trademarks Technical supportUsing the Ulead Photo Explorer Browser BrowserE v i e w Pa n e Photo Explorers built-in Viewer ViewerUlead Instant Viewer windows Downloading Images Onto Your PC Downloading Images From Removable DiskDownloading Images Through Ulead Photo Explorer Error Message Table Message Cause SolutionSpecifications CCDWarranty and After-sales Service System RequirmentsWarranty and After-sales Service FCC Compliance Statement For Home or Office USE