Philips WV-NW484S operating instructions Installing the Camera

Page 21

Installing the Camera

1Install the mounting bracket.

Fix the mounting bracket directly into the ceiling or wall or into the imbedded box using the four screws prepared in advance. (Note that screws for installation are not provided.)

When using the imbedded box, we recommend using two boxes in a row as shown in the figure below on the right. (This is to make it easier to pass the cables through.)

Cable pass-through hole

85 mm

Installation screws x 4

85 mm

Cable pass-through hole

51 mm

Center of metal installation bracket

46 mm

Note..................................................

• When installing the camera outdoors, waterproof the screws

and screw holes.

83.5 mm

......................................................

Installation screws x 4

2Loosen the three screws and remove

the enclosure.

Unscrew the screws using the driver

bit (provided).

Note..................................................

• When replacing the dome cover (WV-CW4C, sold separately), refer to the Operating Instructions provided with the dome cover.

......................................................

21

Image 21

Contents Operating Instructions Accompanying the appliance Important Safety Instructions Limitation of Liability Disclaimer of WarrantyPreface FeaturesAbout these operating instructions System requirements for a PCPreface Network Security Trademarks and Registered TrademarksContents Troubleshooting Specifications Action at an alarm occurrencePrecaution CCD Color Filter Burn-in MPEG-4 Visual patent portfolio license SD Memory CardDo not point the camera at a strong light Source PrecautionConsumables Dehumidifying ElementNames of Components Names of Components Functions Super Dynamic III SUPER-DMotion Detector Progressive output Privacy Zone SettingAuto Back Focus Function Recording to an SD Memory CardEnvironments Power over EthernetInstallation Precautions Installation and ConnectionsAbout Static Electricity Removal Power Supply by PoENetwork Connection Tightening the ScrewsFixing the bracket accessory Before Starting InstallationInstalling the Camera Installing the Camera Install the camera on the mounting Enlarged view of a Power cable Brown Live Connecting the CablesBlue Neutral Green/yellow GNDWaterproofing Cable Joints Connecting the CablesBottom side Water drain groove Adjusting the Camera Adjust the focus How to Change the View Angle Adjusting the CameraHow to Focus capturing subjects with a self-closing lens How to Use the Varifocal Lens and Zoom LensPin Arrangement of 4-pin Alarm Cable accessory Alarm In/Out RatingsInsertion and Removal of SD Memory Cards Handling SD Memory CardsHeater Unit How to Install the Heater UnitConnection Examples Direct connection to a PCNetwork connection via a PoE-compatible hub Installing the Software Network SetupUsing the Panasonic IP Setup Software to Set Up the Camera Software in CD-ROMNetwork Setup Monitor Images on a PC Zoom Monitor Images on a PCMenu. → Setup Manual Monitor images from a single camera Web browser screenLive Monitor images from multiple cameras Multi-screen window Action at an alarm occurrence Alarm typeAction at an alarm occurrence Action at an alarm occurrence Viewing Help Setup screenDisplaying the Help screen Help screenAC/DC power supply TroubleshootingPoE power supply Camera does not Turn onAGC HIGH, F1.4, Wide SpecificationsLOW/HIGH SpecificationsAccessories Panasonic System Solutions Company Panasonic Canada Inc