About Static Electricity Removal
Before installing the camera, touch a metal case or other metallic parts with your hand to remove static electricity from your body.
Do not install in areas subjected to high
amounts of humidity or dust.
Doing so may cause internal components
to damage more easily or malfunction.
Do not wire cables near power lines.
Configure the power supply to the camera so that it can be turned on and off.
The camera does not have a power switch, so configure the power supply to the camera so that it can be turned on and off.
Network Connection
Pay attention to the following points when using the camera's network cable to connect to a network.
•Wire and install the camera so that the network will not be influenced by lightning surges, etc.
•Pan and tilt cannot be used in combina- tion with this camera.
Tightening the Screws
Screws should be tightened sufficiently in accordance with the materials and structure of the installation location. After tightening the screws, visually inspect them to make sure there is no unevenness and that each screw is tight.
Screws should be ordered separately.
The camera does not come with screws. Choose screws in accordance with the materials and structure of the installation location.
Electrical Wave Interference
The image may fluctuate near TV or radio transmission antennas, or near strong electric or magnetic fields (e.g. motors or transformers). In this case, setup a special- ized thin conduit and pass the cable through it.
Power Supply by PoE
Use a
19