AMPSUB210
OWNER’S MANUAL
15 LIGHT BAR DISPLAY
Light Bar Display
On Off
Figure 7. Light Bar Display Control
This switch controls the lighted bars on the front of the amplifier. These bars light red when the amplifier is in operation. If the amplifier is visible and a low light setting is desired use this switch to turn off the light bars. The other LED indicators on the front panel as well as the power button lighted ring are not affected by this control.
16 SPEAKER TERMINALS
17 & 18 | MAINS POWER INLET/FUSE/ |
VOLTAGE SELECTOR |
Power inlet accepts the IEC type line cord supplied with the amplifier. A fuse in the integrated holder provides safety protection from fault conditions: replace fuse with one of same type and rating only.
This amplifier is configured for operation at 115V ~60Hz. (North America)
The AMPSUB210 can be configured for operation from either 115V ~60Hz or 230V ~50Hz AC mains. Installed mains fuse must be of type and rating marked on amplifier corresponding to configured AC mains voltage.
Should you wish to configure the AMPSUB210 for use 230V ~50Hz please contact your dealer or distributor.
Terminals are provided for two subwoofers. Connect the speaker’s positive (red) terminal to the amplifier’s positive (red) terminal, and the speaker’s negative (black) terminal to the amplifier’s negative (black) terminal.
NOTE: Use the appropriate gauge speaker wire when connecting speakers to the AMPSUB210.
If using two speakers they must be a minimum of 8 ohms each. DO NOT BRIDGE. The speaker terminals are internally bridged.
MODEL AMPSUB210 Custom Manufactured in China
115V~ 60Hz 700W FUSE:T6.3AL 250V 230V~ 50Hz 700W FUSE:T3.15AL 250V
- +
Use Class 2 Wiring
Minimum Impedance:
4 ohms Combined Load
CAUTION: See User Manual Before
Replacing Fuse
-+
Figure 8. Speaker Terminals | Figure 9. Mains Power Inlet/Fuse/Voltage Selector |
6 | 9200 North Decatur St. Portland, OR 97203 • 503.286.9300 • www.audiosource.net |
|