Ricoh RDC-i500 manual Seconds when

Page 23

C Insert the connector on the other end of the cable into the USB port of the PC.

D Turn the camera on.

The PC will automatically detect the equipment which has been connected and operate accordingly. If a message is displayed, follow the instructions on the screen.

USB connection is completed.

Before disconnecting the USB cable, check that data transmission is not performed between a camera and a PC, turn off the camera and disconnect the USB cable.

Important

• For Windows Me user, make sure to give a time interval of more than

Note

 

10-seconds when:

Turning off and then on the camera

Setting the mode dial from the modes other than Communication mode to Communication mode.

Inserting and removing the USB cable

Do not remove the RDC-i virtual server process installed in Windows Start-up item folder. The USB connection can not be made without it.

1

Getting Started

21

Image 23
Contents Connecting to a Personal Computer Introduction Simple Operation Guide Read This Before ProceedingContents Recording Images with the Camera Changing the Camera SettingsDirect Upload Settings Using JOB Navi. Func. Image Capture Guide ListAppendix Using the Extension FunctionsSetting the Receiving PC for Direct Upload Page Chapter Getting Started Using the JOB Navi. Func. Image Capture Guide List Tool Kit What You Can Do Using a PCUsing the Camera Control Functions from the Browser Setting the PC for Direct Upload Using the RDC-i Explorer Plug-In / RDC-i MounterUsing the Twain Function For a PC running Windows PC EnvironmentFor Macintosh Connecting the Camera to a Network Connecting MethodsConnecting the Camera to the USB Port For Windows Installing the USB DriverFor Macintosh Installing RDC-i Software Installing the Application SoftwareInstalling JOB Navi. Func. Image Capture Guide List Tool Kit Installing QuickTimeInstalling the RDC-i Twain Driver Installing the RDC-i MounterInstalling QuickTime Installing RDC-i Direct upload Connecting the Camera by USB Cable For Windows Connecting the Camera to the USB PortSeconds when For Macintosh Requirements Connecting the Camera to a NetworkConnecting Procedure COM Port Settings for Windows 98/ME Making the Camera Settings