Ricoh FV-L030B1 manual Reset Mode

Page 19

3.4H Reset Mode

Normally, video noise appears when the beginning of trigger signal is applied before finishing the video readout of the previous frame. This noise is caused by the SUB pulse, which is activated to clear all residual charges on the CCD prior to a new exposure. By selecting this “H. Reset Mode”, the camera automatically holds the actual activation of trigger until the next horizontal blanking period. By doing this, the SUB pulse is activated during the horizontal blanking period and the noise in image can be avoided.

Note: Due to the principal of this operation, there can be maximum “1 H” of delay of actual trigger signal.

Trigger signal (Rising edge）

Next HD

Internal HD

Normal SUB pulse timing

SUB pulse

CCD exposure		Noise
CCD exposure

Video out

	FVL030B1	19/32
	User’s Guide Rev. 1.01	19/32
	User’s Guide Rev. 1.01

Image 19

Contents FVL030B1 User’s Guide Rev VGA CCDTables of Contents Camera Link Connector Connector Specifications/ OUT PowerI/O ConnectorHorizontal Timing Normal Mode Setting 10HPartial Full Scanning Setting 10H 1XX01XXX, 11H Normal Full Scanning Setting 10H 1XX00XXX, 11HVertical Timing FVL030B1 User’s Guide Rev Setting 10H 1XX01XXX, 11H Partial Scanning Setting 10H 1XX01XXX, 11H2.4 1/4 Partial Scanning SUB Variable Partial Scanning Setting 10H 1XX01XXX, 11HBinning Mode Setting 10H Binning Partial Full Scanning Setting 10H 1XX10XXX, 11HSetting 10H 1XX11XXX, 11H Vertical Timing Binning Full ScanningBinning 1/4 Partial Scanning Binning 1/2 Partial ScanningData Order on the Camera Link Output XclkPixel Transferring Image 1 Taps Transferring Image（1X1Y ）Frame Exposure Normal ModeElectric Shutter Pulse Width Trigger Mode（VReset ） Pulse Width Trigger ModeExposure Timing Pulse Width Trigger Mode NonResetEdge Preset Trigger Mode VReset Edge Preset Trigger ModeEdge Preset Trigger Mode NonReset Reset Mode Communication Method Communication SettingsCommunication Format Name Descriptions 【Example Code】Reading the data from the command 00H Eeprom Camera Control Command Camera Command List24/32 Underline settings are the factory default settings Descriptions of the Camera Control Commands26/32 27/32 28/32 29/32 30/32 31/32 32/32