Radio Shack STC-TGL2M, STC-TGL4M, STC-TGL5M user manual Toll Free

Page 13

Wildview Series

f.Press [SET] button to enter date setting. Date &

DDwill blink. Press [UP] or [DN] to adjust date.

g.Press [SET] button to enter year setting. Date &

YYwill blink. Press [UP] or [DN] to adjust year.

h.Press and hold [SET] button for 2 seconds to exit the setting mode and enter into PIR count down mode. Display will show date and number of picture taken.

Once the program setting has been completed, slide the power switch to OFF position until you are ready for field use.

NOTE: Date & Time setting will be lost whenever the batteries are removed from camera. Don’t forget to re- set the Date & Time stamp after you replace the batteries.

www.wildviewcam.com

Toll Free 888-304-6125

13

Image 13
Contents User’s Manual Toll Free Customer Support STC-TGL2M / STC-TGL4M / STC-TGL5MWildview Limited Warranty Manual Contents Camera overview Front view Side view Open view image with major parts indication Battery & memory installation Camera kit contentsToll Free Sdram ™ SD cards must be clean no images from other sources STC-TGL2M STC-TGL4M STC-TGL5M DefinitionProgramming your Wildview Camera Toll Free Toll Free Mounting the camera Toll Free Wildview Series Toll Free Viewing images Toll Free Toll Free Saving Images Saving and Deleting imagesToll Free Toll Free PQI SD card Compatibility ChartTechnical Specifications Qvga Toll Free General Information Toll Free AVI Built In 32MB AVI Toll Free