Chapter 2: Remote Control
Using the INPUT Button
Use the INPUT button to scroll through the available Video Input Channel sources for a TV or VCR and regular broadcast signals. The Video Input Channels allow you to view images from a component connected to the TV or VCR (such as a camcorder or DVD player).
1.Press the remote controlÕs TV or AUX button (if programmed) to enter the corresponding mode. Make sure the component is turned ON.
2.Press the remote controlÕs INPUT button to tune to the Video Input Channel.
3.To tune back to the broadcast signal you were previously watching through the TV or VCR, press the INPUT button again.
Volume Punchthrough
You may find this feature helpful if youÕve connected your components to an audio/video receiver (A/V receiver) or amplifier, but you want to use the decoderÕs remote control to operate the volume.
LetÕs say youÕve connected your IP video decoder to your audio/video receiver. YouÕve also programmed your decoder remote control to operate your receiver. Since the decoder gets its volume through the receiver, you would have to tell the remote you wanted to change the volume on the receiver each time by pressing the AUX button first. With Volume Punchthrough, you can control the receiverÕs volume, even when the remote is in decoder mode. Just use the volume buttons as normal, and youÕll change the receiverÕs volume automatically (or whatever volume component you used last).
IMPORTANT: You must first program the AUX button on the decoder’s remote control to operate your audio receiver or amplifier. Go to page 14 for instructions. If you can’t program this remote to operate your audio receiver, Volume Punchthrough won’t work.
Chapter 2 | Illustrations contained in this document are for representation only. | 13 |