Power Your Camcorder
Use the Battery to Power Your Camcorder (continued)
Hold Battery Flush | Reference |
and Slide | Marks |
To AC Wall
Outlet 100-
240 Volts,
50/60 Hz.
CHG (Charge) Indicator
REFRESH | Adapter/Charger |
Indicator |
|
REFRESH
Button
Caution: When a battery is attached to the adapter/charger, do not turn them upside down. The battery may fall off and be damaged or cause injury.
Charge the Battery
If the DC cable is attached to the DC OUT jack on the adapter/charger, remove it.
1.Align reference mark on battery with mark on adapter/charger.
2.Hold the battery flush against the adapter/charger and slide it in the direction of the arrow.
3.Plug adapter/charger into nearest AC outlet
4.If the battery is properly connected, the CHG indicator flashes.
Note: If you try to charge a battery that has not been charged for a long period of time, it may take a few minutes for the CHG indicator to flash.
5.After the battery is charged, the CHG indicator stops flashing and lights.
6.Remove the charged battery by sliding it off the adapter/charger.
7.Attach the charged battery to the camcorder.
Use the REFRESH Button
The battery provides increased operation time if you “refresh” it after five chargings. The refresh feature “refreshes” the battery by completely discharging it.
1.Attach battery to adapter/charger.
2.Press REFRESH. The REFRESH indicator lights and the battery begins discharging.
3.When discharging is completed, the REFRESH indicator turns off, and
14