Remote Control
Install Lithium Cell
The remote’s lithium cell is packed separately. Install it as follows:
Back of
Remote Control
Holder
Insert Pencil Here
Lithium Cell
Cautions: Lithium cell battery. Replace only with
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
1.Turn remote over, insert a pencil or paper clip in small hole and remove battery holder.
2.Insert battery in battery holder so positive (+) terminal faces up.
3.Replace battery holder in remote until it clicks into place.
Notes: Never place anything heavy on top of the remote control or lay it
Replace battery when camcorder fails to respond to remote.
Remove battery from remote if it will not be used for a month or more. This will prevent possible damage from battery leakage.
If leakage occurs, wipe up liquid inside compartment and replace battery.
Remote Sensor
The remote operates the camcorder by infrared light, so it is protected from electrical and sound interference. However, the remote must be aimed directly at the camcorder’s remote sensor. There cannot be any obstructions between them.
Remote Control Sensor
F1
MODE
F2
H
S
U
P
T
U
A
AE select scene
| ZOOM | |
| PLAY | START/STOP |
| STOP |
|
| TIME | INTSELF |
| REW | TIME. |
| REC |
|
| TIME LAPSE | |
INSERT | ANIM |
|
| PAUSE. |
|
| FF |
|
| A |
|
| DUB. |
|
Note: The camcorder may not respond to the remote if its sensor is exposed to direct sunlight or strong artificial light.
18