SonicWALL SRA 1200/4200 manual Configuring a Default Route

3.In the Interface Settings dialog box, set the IP address and subnet mask to:

If you are using scenario:	Set the X0 interface to:
B - SRA on an Existing DMZ	IP Address: An unused
	address within your DMZ
	subnet, for example:
	10.1.1.240
	Subnet Mask: Must match
	your DMZ subnet mask
C - SRA on the LAN	IP Address: An unused
	address within your LAN
	subnet, for example:
	192.168.168.200
	Subnet Mask: Must match
	your LAN subnet mask

4.Click OK. Note that you will lose connection to the SRA.

5.Reset the management computer to have a static IP address in the range you just set for the X0 interface, for example, 10.1.1.20 or 192.168.200.20.

6.Log into the SRA management interface again, using the IP address you just configured for the X0 interface. For example, point your browser to http://192.168.168.200.

Configuring a Default Route

Refer to the following table to correctly configure your default route. If you do not know your scenario, refer to “Selecting a Deployment Scenario” on page 7.

If you are using scenario:	Your upstream gateway device
	will be:
A - SRA on a New DMZ	The DMZ interface you will
	create
B - SRA on an Existing DMZ	The existing DMZ interface
C - SRA on the LAN	The LAN gateway

To configure a default route:

1.Navigate to the Network > Routes page.

2.Enter the IP address of your upstream gateway device in the Default Gateway field.

3.Select X0 in the Interfaces drop-down list.

4.Click Accept.

SonicWALL SRA 1200/4200 Getting Started Guide Page 15