Profoto D1 250 Air, D1 1000 Air, D1 500 Air manual Modeling light setting, Ready signaling setting

Page 14

AirStudio

Profoto–

USBAir

Profoto

14

Modeling light setting

1.Use the Model Button [10a] to select the modeling light:

a.To select proportional modeling light,press and hold down the Model Button [10a] until the PROP Indicator [10b] is illuminated.

b.To select free modeling light,press and hold down the Model Button [10a] until the FREE Indicator [10c] is illuminated.The energy level of the latest selected free modeling light setting will be activated.

c.To turn off the modeling light, press the Model Button [10a]. Both the PROP Indicator [10b] and the FREE Indicator [10c] will be turned off.Press the Model Button [10a] again to turn on the modeling light.

Change the level of the free modeling light:

1.Verify that free modeling light setting is selected (the FREE Indicator [10c] shall be illuminated when the modeling light is turned on).

2.Press the Model Set Button11][ .The Display [1]will start flashing,showing the current energy level of the Free modeling light.

3.While the Display [1] is flashing,use the Setting Knob [7] to change the energy level:

a.Turn the Setting Knob [7] clockwise to increase the energy level in 1/10 f-stop increments and counter-clockwise to decrease.

b.Press and hold down the Setting Knob [7] and turn the knoblockwise to increase the energy in 1 f-stop increments and counter-clockwise to decrease.

4.Wait until the Display [1] stops flashing(The. Display [1] will now show the energy level of the flash light.)

Ready signaling setting

1.Use the Ready Button [9a] to select the ready signaling:

a.To select sound signaling, press and hold down the Ready Button [9a] until the BEEP Indicator [9b] is illuminated.

b.To select light signaling,press and hold down the Ready Button [9a] until the DIM Indicator [9c] is illuminated.

c. To select both sound and light signaling, press and hold do wn the Read y Button [9a] until both the BEEP Indica tor [9b] and the DIM Indica tor [9c] are illuminated.

d.To turn off the read y signaling, press the Read y Button [9a]. Both the BEEP Indicator [9b] and the DIM Indicator [9c] will be turned offPress. the Ready Button [9a] again to turn on the ready signaling.

www.profoto.com

Image 14
Contents D1 1000 Air D1 500 Air D1 250 Air AirStudio Profoto Thank you for choosing Profoto Safety instructions Safety PrecautionsTable of Contents System description Profoto AirProfoto Air USB Profoto Air RemoteProfoto Air Sync Profoto Studio AirSlave Setting NomenclatureSync Connector Locking Knob Modeling light Sync signalingEnergy control Flash before ready Ready signalingReady indicator/Test function Reflector Remote controlColor temperature UmbrellaOperating instructions Modeling light setting Ready signaling settingSync via IR Radio settings D1with Profoto AirSync via cable Sync via radio D1without Profoto AirTurn off unit Clasp Flash tube Modeling lamp MaintenanceChanging flash tube and/or modeling lamp Changing built-in fuse Adaptive thermal control 250 Air 1000 Air500 Air 500Synchronization modes This page is intentionally left blank This page is intentionally left blank Change without notice
Related manuals
Manual 24 pages 25.32 Kb