Profoto D1 500 Air, D1 1000 Air, D1 250 Air manual Safety instructions, Safety Precautions

Page 4

AirStudio

Profoto–

USBAir

Profoto

4

Safety instructions

SAFETY PRECAUTIONS!

Read and follow all safety instructions below carefully to avoid injuries or damages! Make sure that Profoto Safety Instructions is always accompanied the equipment! Profoto products are intended for professional use! Generator, lamp heads and accessories are only intended for indoor photographic use. Do not place or use the equipment where it can be exposed to moisture,extreme electromagnetic fields or in areas with flammable gases or dust! Do not expose the equipment to dripping or splashingDo not. place any objects filled with liquids on or near the equipmentDo. not expose the equipment to hasty temperature changes in humid conditions as this could lead to condensation water in the unit. Do not connect this equipment to flash equipment from other brands. Do not use flash heads without supplied protective glass covers or protective grids. Glass covers shall be changed if it has become visibly damaged to such an extent that their effectiveness is impaired,for example by cracks or deep scratches. Lamps shall be changed if they are damaged or thermally deformed.When placing a lamp into the holder ensure not to touch the bulb with bare hands. Equipment must only be serviced, modified or repaired by authorized and competent service personnel!

WARNING – Electrical Shock – High Voltage!

Mains powered generator shall always be connected to grounded mains power supply outlet! Only use Profoto extension cables! Do not open or disassemble generator or lamp head! Equipment operates with high voltage. Generator capacitors are electrically charged for a considerable time after being turned off. Do not touch modeling lamp or flash tube when mounting umbrella metal shaft in its reflector hole.

Disconnect lamp head cable between generator and lamp head when changing modeling lamp or flash tube!

Caution – Burn Hazard – Hot Parts!

Do not touch hot parts with bare fingers! Modeling lamps, flash tubes and certain metal parts emit strong heat when used! Do not point modeling lamps or flash tubes toolosec to persons. All lamps may on rare occasions explode and throw out hot particles! Make sure that rated voltage for modeling lamp corresponds with technical data of user guide regarding power supply!

NOTICE – Equipment Overheating Risk

Remove transport cap from lamp head before use! Do not obstruct ventilation by placing filters,diffusing materials, etc. over inlets and outlets of the equipment ventilation or directly over glass cover, modeling lamp or flash tube!

Final Disposal

Equipment contains electrical and electronic components that could be harmful to the environment. Equipment may be returned to Profoto distributors free of charge for yclingrec according toWEEE. Follow local legal requirements for separate disposal of waste, for instance WEEE directive for electrical and electronic equipment on the European market,when product life has ended!

www.profoto.com

Image 4
Contents D1 1000 Air D1 500 Air D1 250 Air AirStudio Profoto Thank you for choosing Profoto Safety instructions Safety PrecautionsTable of Contents System description Profoto AirProfoto Air Remote Profoto Air SyncProfoto Air USB Profoto Studio AirSlave Setting NomenclatureSync Connector Locking Knob Energy control Sync signalingModeling light Ready indicator/Test function Ready signalingFlash before ready Remote control Color temperatureReflector UmbrellaOperating instructions Modeling light setting Ready signaling settingRadio settings D1with Profoto Air Sync via cableSync via IR Sync via radio D1without Profoto AirTurn off unit Changing flash tube and/or modeling lamp MaintenanceClasp Flash tube Modeling lamp Changing built-in fuse Adaptive thermal control 1000 Air 500 Air250 Air 500Synchronization modes This page is intentionally left blank This page is intentionally left blank Change without notice
Related manuals
Manual 24 pages 25.32 Kb