Harbor Freight Tools 94634 operating instructions INSPECTION, MAINTENANCE, and Cleaning

Page 19

INSPECTION, MAINTENANCE, AND CLEANING

1.WARNING! Make sure the Power Switch (14) of the Curb Machine is in its “OFF” position and the machine is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

2.Before each use, inspect the general condition of the Curb Machine. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

3.After each use, clean the Hopper, Chute, Slip Form, and exterior Body of the Curb Machine thoroughly with water. Do not introduce water into the Motor compart- ment of the machine.

4.To replace the V-Belt,loosen the four Bolts (48) at the base of the Motor (25). Move the Motor towards the Gear Box (24). Slip the V-Belt (20) off the two Pulleys (21, 23). Install a new V-Belt (size A500) onto the two Pulleys. Move the Motor back to its original position. Then, firmly retighten the four Bolts.

(See Assy. Diagram.)

SKU 94634

For technical questions, please call 1-800-444-3353

PAGE 19

Image 19

Contents Curb Machine KIT With Forms For technical questions or replacement parts, please callWork Area Product SpecificationsGeneral Safety Rules Save this ManualPersonal Safety Electrical SafetyTool USE and Care ServiceIndustrial applications must follow Osha guidelines Specific Safety RulesKeep all safety guards in place and in proper working order Grounded Tools Tools With Three Prong Plugs GroundingSee Figure C See Figure C, nextAt full load UnpackingNameplate Extension Cord Length 120 or 240 VoltSee Figure E, next Product FeaturesSee Figure E, and Assy. Diagram Product OverviewFigure E To Install a Slip Form Assembly InstructionsSee Figure E SKU For technical questions, please call Setting UP the Curb MachineTrenching Guide New Landscape Before Sod Ground PreparationOperating Instructions Mixing the ConcreteOperating The Curb Machine See Figure E Feeding The Hopper Installing Curbing In a Straight LineHand Troweling Cutting Control Joints Installing Curved CurbingInstalling Circles Finishing Into a Solid ObjectSealing When The Job Is FinishedCaring For The New Curbing See Assy. Diagram SKU For technical questions, please call INSPECTION, MAINTENANCE, and CleaningProblem Possible Solution TroubleshootingPlease Read the Following Carefully Parts List1715 1718 27 26 2122 243 6158 6359 6449 Assembly DiagramLimited 1 Year warranty