Cisco Systems ASR 903 manual Activating the DC Power Supply, 3-23

Chapter 3 Installing the Cisco ASR 903 Router

Installing the Power Supply

Caution Secure the wires coming in from the terminal block plug so that they cannot be disturbed by casual contact.

Step 7 Ensure that the terminal block plug is fully seated in the terminal block header on the DC power supply panel. The plug has a locking feature. You should hear a snap or click when it is installed properly.

Step 8 Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block plug by casual contact. Make sure the tie wrap allows for some slack in the ground wire, as shown in Figure 3-20.

Figure 3-20 Complete DC Terminal Block Plug Insertion and Secure Tie Wrap

RUDY RSP

INPUT

OK

OUTPUT

FAIL

MEM
CONSOLE	1PPS	1PPS
	IN		1OMHZ
		OUT		1OMHZ	S
			IN
				OUT	YNC
				TOD	ACT
				BITS	PWR
				MGMT
					STAT
				ENET

24V—60V	28A
	24V—60V	28A

2

FAN TEMP
CRIT	MAJ MIN

ALARM

255731

1

1

Lead wires secured with a tie wrap

2

DC power supply terminal block plug being inserted into terminal block header.

Step 9 Use a tie wrap to secure the wires to the handle. Leave a service loop on the ground wire between the handle and the connector such that it is the last to receive strain if the wires are pulled.

This completes the procedure for connecting the DC power supply in the Cisco ASR 903 Router.

If you are installing a redundant DC power supply, repeat these steps for the second power source.

Activating the DC Power Supply

Perform the following procedure to activate the DC power supply:

Step 1 Remove the tape from the circuit-breaker switch handle, and restore power by moving the circuit-breaker switch handle to the On () position.

Step 2 Verify power supply operation by checking if the power supply front panel LEDs are in the following states:

	Cisco ASR 903 Router Hardware Installation Guide
OL-25178-04		3-23