Cisco Systems manual Safely Powering Off the Cisco ASR 903 Router

Chapter 4 Cisco ASR 903 Router Initial Configuration

Safely Powering Off the Cisco ASR 903 Router

Safely Powering Off the Cisco ASR 903 Router

This section explains how to shut down the Cisco ASR 903 Router. It is recommended that before turning off all power to the chassis, you issue the reload command. This insures that the operating system cleans up all the file systems. Once the reload operation is complete, then the

Cisco ASR 903 Router can be powered off safely.

To remove power from the Cisco ASR 903 Router safely, follow this procedure and see the examples:

Step 1 Slip on the ESD-preventive wrist strap that was included in the accessory kit.

Step 2 Enter the reload command.

Step 3 Confirm the reload command.

Rmcp-6ru-1#reload

Proceed with reload? [confirm]

Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis code

Step 4 After confirming the reload command, wait until the system bootstrap message displays before powering off the system.

System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)

Technical Support: tap://www.cisco.com/techsupport

Copyright (c) 2008 by cisco Systems, Inc.

Current image running: Boot ROM0

Last reset cause: LocalSoft

ASR1000-RP1 platform with 4194303 Kbytes of main memory

mcp-6ru-1-rp0-rommon 1>

Step 5 Remove any power cables from the Cisco ASR 903 Router.

a.For power supplies with a circuit breaker switch, position the switch to the Off (O) position.

b.For power supplies with a Standby switch, place the Standby switch in the Standby position.

Note After powering off the router, wait a minimum of 30 seconds before powering it on again.

Cisco ASR 903 Router Hardware Installation Guide

4-8 OL-25178-04