Chapter 4 Cisco ASR 903 Router Initial Configuration
Powering Up the Cisco ASR 903 Router
Powering Up the Cisco ASR 903 Router
Make certain that all card slots and compartments are closed off. Install blank faceplates on any empty slots. Always have power supply slots filled. If you leave a power supply slot uncovered, then you risk exposure to hazardous voltages on the power pins on the midplane.
Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement 1029
After installing your Cisco ASR 903 Router and connecting cables, start the router and follow these steps:
Step 1 Activate the DC power supply using the steps described in “Activating the DC Power Supply” procedure on page
Caution Do not press any keys on the keyboard until the messages stop and the SYS PWR LED is solid green. Any keys pressed during this time are interpreted as the first command typed when the messages stop, which might cause the router to power off and start over. It takes a few minutes for the messages to stop.
Note This is only an example of what can display. The system boots differently depending upon the configuration that ships with your system.
Step 2 Observe the initialization process. When the system boot is complete (the process takes a few seconds), the Cisco ASR 903 Router RSP begins to initialize.
Example 4-1 Loading the Default System Boot Image
rommon 1 > rommon 1 > boot
Located rp_super.ppc.nader.5g.evfc.bin
Image size 211681484 inode num 12, bks cnt 51681 blk size 8*512
######################################################################################
#
#############################################
Boot image size = 211681484 (0xc9e00cc) bytes
|
|
| Using midplane macaddr |
|
| ||
|
|
| Package header rev | 0 structure detected | |||
|
|
| Calculating | ||||
|
|
| validate_package: | hash: | |||
|
|
| calculated | 479a7d62:6c128ba8:3616b8da:93cb3224:5c1aeb34 | |||
|
|
| expected | 479a7d62:6c128ba8:3616b8da:93cb3224:5c1aeb34 | |||
|
|
| Image validated |
|
|
|
|
|
|
| PPC/IOS XE loader version: 0.0.3 | ||||
|
|
| loaded at: | 00800000 | 0D1E2004 | ||
|
|
| zimage at: | 00807673 | 009B8C69 | ||
|
|
| Cisco ASR 903 Router Hardware Installation Guide |
|
| ||
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| ||
