Cisco Systems ASR 903 manual Chassis-Lifting Guidelines, Tools and Equipment, 2-20

Chapter 2 Preparing for Installation

Receiving the Cisco ASR 903 Router

Chassis-Lifting Guidelines

The chassis is not intended to be moved frequently. Before you install the system, ensure that your site is properly prepared so that you can avoid having to move the chassis later to accommodate power sources and network connections.

Two or more people are required to lift the chassis. Each time you lift the chassis or any heavy object, follow these guidelines:

•Never attempt to lift the chassis by yourself. Because of the size and weight of the chassis, use at least two people to safely lift and move it without causing injury to yourself or damaging the equipment.

•Ensure that your footing is solid, and balance the weight of the chassis between your feet.

•Lift the chassis slowly; never move suddenly or twist your body as you lift.

•Keep your back straight and lift with your legs, not your back. If you must bend down to lift the chassis, bend at the knees, not at the waist, to reduce the strain on your back muscles.

•Do not remove installed components from the chassis.

•Always disconnect all external cables before lifting or moving the chassis.

Warning To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles on modules (such as power supplies, fans, or cards); these types of handles are not designed to support the weight of the unit. Lift the unit only by using handles that are an integral part of the chassis, or by grasping the chassis underneath its lower edge. Statement 163

Perform the following to lift a chassis:

Step 1 Each person should stand on either side of the chassis and place one hand under the air intake at the bottom front of the chassis.

Step 2 With the other hand, grasp the top rear of the chassis under the air exhaust, and carefully lift the chassis.

Tools and Equipment

You need the following tools and equipment to install and upgrade the router and its components:

•ESD-preventive cord and wrist strap

•Antistatic mat or antistatic foam

•Number 1 and Number 2 Phillips-head screwdrivers

•Flat-blade screwdrivers: Small 3/16-inch (0.476 cm) and medium 1/4-inch (0.625 cm):

–To install or remove modules

–To remove the cover if you are upgrading the memory or other components

•#12-24 pan-head screws to secure the router to the equipment rack

•Cables for connecting to the WAN and LAN ports (depending on the configuration)

	Cisco ASR 903 Router Hardware Installation Guide
2-20	OL-25178-04