Yamaha DVX-S100 owner manual Speaker settings DVD-A DVD-V, Output mode

SETUP MENU

Speaker settings DVD-ADVD-V

When you adjust speakers while DISC DIRECT is functioning, follow the procedures described below.

					VIDEO 1
	CODE SET			CD
	SHIFT			DVD	AMP
	HALL	JAZZ		ROCK	ENTERTAINMENT
	1	2		3	4
		SETUP		ANGLE	MARKER
	SPORTS MONO MOVIE			MOVIE 1	MOVIE 2
	5	6		7	8
		PLAY MODE		REPEAT	A–B
	/DTS	SELECT		MATRIX 6.1	STEREO
	9	0		>	CANCEL
				–10
				GROUP	PAGE
	TOP MENU		MENU
	LEVEL	SET MENU			MUTE
		PRESET		ABCDE
u, d, j, i	CH	ENTER		CH
/ ENTER		PRESET
	TEST		B. BOOST		VOL
	ON SCREEN		RETURN

(U.S.A. model)

If you wish to enjoy multi-channel sound reproduction, you need to select “Multi-channel” on the setup menu and make following adjustments.

When you select “2-channel”, that is, when connecting to only 2 speakers or a Dolby Pro Logic decoder, the following adjustments are not necessary.

	Front (L)		Center		Front (R)
	a		b a c		a
	Exit
SETUP
	L	ms	C	dB	R
		0		0
	Exit			dB	SW
	Test
				0
SELECT
	LS	dB	ms	dB	RS
		0	0	0
ENTER	RETURN

Test signal

Rear Subwoofer

(L) a (L) c b (R) c (R) a b a

aOutput mode

Change the settings of each speaker in accordance with your speaker system.

1Press the cursor buttons (u, d, j, i) to select a speaker and press ENTER.

2Press the cursor buttons (u, d) to select the setting and press ENTER.

•Choices of the speaker size L: Large, Small

R: Large, Small

C:Large, Small, None SW: Used, Not used LS: Large, Small, None RS: Large, Small, None

The size of L is set to be the same as that of R. Therefore, if you select Large for L, the size of R is automatically set to Large. This also applies to the sizes of LS and RS.

• Example: Rear left speaker

1	2	3
	LS	LS

1 when the speaker is not used.

2 when using a large speaker capable of low- frequency (under 100 Hz) output.

3 when using a small speaker that is not capable of

low-frequency output. (the included speakers, NX-S100S etc.)

•Factory settings of the speaker sizes L/R: Large

C/LS/RS: Large

SW: Used

52